Ads
related to: ohv engine vs ohc motors
Search results
Results from the WOW.Com Content Network
This contrasts the earlier overhead valve engine (OHV) and flathead engine configurations, where the camshaft is located down in the engine block. The valves in both OHC and OHV engines are located above the combustion chamber; however an OHV engine requires pushrods and rocker arms to transfer the motion from the camshaft up to the valves ...
Simpler camshaft drive system: OHV engines have a less complex drive system for the camshaft than OHC engines. [16] Most OHC engines drive the camshaft or camshafts using a timing belt, a chain, or multiple chains. These systems require the use of tensioners, which add complexity. In contrast, an OHV engine has the camshaft positioned close to ...
Considered advanced by Detroit engineering standards at the time, the Pontiac OHC 6 followed the Jeep Tornado I6 as the second post-World War II domestic-developed and mass-produced overhead cam automobile engine. [6] The Pontiac's single camshaft was supported by journals within the aluminum valve cover; no separate bearing shells were used.
The engine was discontinued in 2003, replaced by the 2.2-liter DOHC Ecotec engine. Although it displaces 134 cu. in, the 2.2-liter OHV is still commonly referred to as the GM 122 today, and has been reputed for its simplicity, reliability, and ease of maintenance in the J-body cars and S-series trucks, and a few L-body cars.
In the 1950s, Ford introduced a three-tier approach to engines, with small, mid-sized, and larger engines aimed at different markets. All of Ford's mainstream V8 engines were replaced by the overhead cam Modular family in the 1990s and the company introduced a new large architecture, the Boss family, for 2010.
OHC engines always have fewer parts when comparing systems with the same number of valves and cylinders (4 cylinder 2 valve OHC engine to 4 cylinder 2 valve OHV engine). Though it is true that some OHC engines do come close to the high moving part count of an OHV engine it is very rare. The Honda SOHC C series V6 engines for example had a ...
American Motors' first straight-six engine was the 196 cubic inch (195.6 cu in (3.2 L)) six produced from 1952 through 1965, initially as a flathead (L-head) side-valve, and later an overhead valve (OHV) version. This was originally designed to be an economy engine by Nash Motors, being introduced in the 1941 Nash Ambassador 600 model.
Later engines of over two litres received longer strokes; up to 77.5 mm (3.05 in) for the 2.2 and 85 mm (3.35 in) for the 2.4 (also used for the 3.6 litre inline-six version). 1.9L Opel CIH - side cross-section. While an improvement over a cam-in-block engine, the advantages over an OHC design were limited.
Ads
related to: ohv engine vs ohc motors