Search results
Results from the WOW.Com Content Network
A 5% displayed LFL reading for methane, for example, would be equivalent to 5% multiplied by 4.4%, or approximately 0.22% methane by volume at 20 degrees C. Control of the explosion hazard is usually achieved by sufficient natural or mechanical ventilation, to limit the concentration of flammable gases or vapors to a maximum level of 25% of ...
Class 3: Flammable Liquids A flammable liquid is a liquid having a flash point of not more than 60 °C (140 °F), or any material in a liquid phase with a flash point at or above 37.8 °C (100 °F) that is intentionally heated and offered for transportation or transported at or above its flash point in a bulk packaging. The following exceptions ...
A flammable liquid is a liquid which can be easily ignited in air at ambient temperatures, i.e. it has a flash point at or below nominal threshold temperatures defined by a number of national and international standards organisations.
Flammable gases – Gases which at 20 °C and a standard pressure of 101.3 kPa: are ignitable when in a mixture of 13 percent or less by volume with air; or; have a flammable range with air of at least 12 percentage points regardless of the lower flammable limit. Alternative sign. Division 2.1 Non-flammable non-toxic gases – Gases which:
Division 4.1: Flammable Solid . Flammable solids are any of the following four types of materials: Desensitized Explosives: explosives that, when dry, are Explosives of Class 1 other than those of compatibility group A, which are wetted with sufficient water, alcohol, or plasticizer to suppress explosive properties; and are specifically authorized by name either in the 49CFR 172.101 Table or ...
Although the first meeting of the ACGIH was held in 1938, the first exposure limits of the group were not published until 1946, then referred to as Maximum Allowable Concentrations. These standards were split into 4 categories: Gasses and Vapors, Toxic Dusts, Fumes, and Mists, Mineral Dusts, and Radiations.
The lower flammability limit (LFL), [1] usually expressed in volume per cent, is the lower end of the concentration range over which a flammable mixture of gas or vapour in air can be ignited at a given temperature and pressure.
The maximum allowable amount of benzene in workroom air during an 8-hour workday, 40-hour workweek is 1 ppm. As benzene can cause cancer, NIOSH recommends that all workers wear special breathing equipment when they are likely to be exposed to benzene at levels exceeding the recommended (8-hour) exposure limit of 0.1 ppm. [88]