Ads
related to: injecting leak sealing clamp
Search results
Results from the WOW.Com Content Network
Injection molding of liquid silicone rubber (LSR) is a process to produce pliable, durable parts in high volume. Liquid silicone rubber is a high purity platinum cured silicone with low compression set, good stability and ability to resist extreme temperatures of heat and cold ideally suitable for production of parts, where high quality is ...
Injection moulding uses a special-purpose machine that has three parts: the injection unit, the mould and the clamp. Parts to be injection-moulded must be very carefully designed to facilitate the moulding process; the material used for the part, the desired shape and features of the part, the material of the mould, and the properties of the ...
Classical patch clamp setup, with microscope, antivibration table, and micromanipulators. During a patch clamp recording, a hollow glass tube known as a micropipette or patch pipette filled with an electrolyte solution and a recording electrode connected to an amplifier is brought into contact with the membrane of an isolated cell.
In mechanical engineering, an end-face mechanical seal (often shortened to mechanical seal) is a type of seal used in rotating equipment, such as pumps, mixers, blowers, and compressors. When a pump operates, the liquid could leak out of the pump between the rotating shaft and the stationary pump casing. Since the shaft rotates, preventing this ...
An injection molding machine (also spelled as injection moulding machine in BrE), also known as an injection press, is a machine for manufacturing plastic products by the injection molding process. It consists of two main parts, an injection unit and a clamping unit .
In the course of sealing castings against porosity, the parts would be processed through the following four stations: Impregnation Chamber: The operator would seal the chamber and draw a vacuum. This would remove air in the porosity and leak path in the casting wall. Parts would then be covered with sealant, and positive pressure applied.
A gland is a general type of stuffing box, used to seal a rotating or reciprocating shaft against a fluid. The most common example is in the head of a tap where the gland is usually packed with string which has been soaked in tallow or similar grease.
Screw clamps consist of a band, often galvanized or stainless steel, into which a screw thread pattern has been cut or pressed. One end of the band contains a captive screw. The clamp is put around the hose or tube to be connected, with the loose end being fed into a narrow space between the band and the captive screw.
Ads
related to: injecting leak sealing clamp