Ads
related to: 8 ohm woofer replacement for rv fanebay.com has been visited by 1M+ users in the past month
campingworld.com has been visited by 100K+ users in the past month
Great prices. Fast delivery. Very satisfied. - Bizrate
Search results
Results from the WOW.Com Content Network
The NS-10 is an 8-ohm two-way loudspeaker with a 10.4-litre sealed cabinet measuring 382 × 215 × 199 millimetres (15.0 × 8.5 × 7.8 in) and weighing 6 kilograms (13.2 lb). [5] [4] Its 2.5 cm (0.98 in) particle-board cabinet has a wood veneer skin with seven black finishing layers. The domestic version of the speaker was vertically oriented ...
The voltage is constant only in the sense that at full power, the voltage in the system does not depend on the number of speakers driven (as long the amplifier's maximum power is not exceeded). [2] Constant-voltage speaker systems are also commonly referred to as 25- , 70- , 70.7- , 100 or 210-volt speaker systems ; distributed speaker systems ...
In the late 1940s, horns whose mouths took up much of a room wall were not unknown among hi-fi fans. Room-sized installations became much less acceptable when two or more were required. A horn-loaded speaker can have a sensitivity as high as 110 dB at 2.83 volts (1 watt at 8 ohms) at 1 meter. This is a hundredfold increase in output compared to ...
Tweeters can also work in collaboration with the woofers that are responsible for generating the low frequencies or bass. [2] Some tweeters sit outside the main enclosure in their own semi-independent unit. Examples include "super tweeters" and the novel "egg tweeter" by Ohm. The latter plugs in and swivels to adjust the soundfield depending on ...
A rotary woofer is a subwoofer-style loudspeaker which reproduces very low frequency content by using a conventional speaker voice coil's motion to change the pitch (angle) of the blades of an impeller rotating at a constant speed. The pitch of the fan blades is controlled by the audio signal presented to the voice coil, and is able to swing ...
A large wood block was bolted between the back of the woofer magnet and the back panel of the enclosure, as a structural brace, a technique later used by other manufacturers. Crossover network components were attached onto three sides of this block. Since it was designed for use with valve (tube) amplifiers, the system was rated at 15 Ohms.