Search results
Results from the WOW.Com Content Network
However, if the packet is forwarded further, the Router Alert Label should be pushed back onto the label stack before forwarding. The use of this label is analogous to the use of the "Router Alert" option in IPv4 packets. Since this label cannot occur at the bottom of the stack, it is not associated with a particular network-layer protocol.
Wireless router [2] An internet box integrating a SIM Card. A modem (e.g. DSL modem, cable modem) by itself provides none of the functions of a router. [3] It merely allows ATM or PPP or PPPoE traffic to be transmitted across telephone lines, cable wires, optical fibers, wireless radio frequencies, or other physical layers. [4]
In a typical home or small-office setup, a single router is the only device visible to an Internet service provider (ISP), and the ISP may try to provide a configuration that is as stable as feasible, i.e. sticky. On the local network of the home or business, a local DHCP server may be designed to provide sticky IPv4 configurations, and the ISP ...
The default gateway can be specified by the route command to configure the node's routing table and default route. In a home or small office environment, the default gateway is a device, such as a DSL router or cable router, that connects the local network to the Internet. It serves as the default gateway for all network devices.
A DSL modem, which is type of customer-premises equipment. The WAN interface of this device, in this case the DSL port, could expose CWMP to the internet service provider . Technical Report 069 ( TR-069 ) is a document by the Broadband Forum that specifies the CPE WAN Management Protocol ( CWMP ).
[3] [4] Where a computer is connected to a cable or DSL modem, it may have to be plugged directly into the modem network port to bypass the router, before using ipconfig /release and turning off the power for a period of time, to ensure that the old IP address is taken by another computer.
In network topology, a cable modem is a network bridge that conforms to IEEE 802.1D for Ethernet networking (with some modifications). The cable modem bridges Ethernet frames between a customer LAN and the coax network. Technically, it is a modem because it must modulate data to transmit it over the cable network, and it must demodulate data ...
The modem connects to a single computer or router, through an Ethernet port, USB port, or is installed in a computer PCI slot. The more common DSL router is a standalone device that combines the function of a DSL modem and a router , and can connect multiple computers through multiple Ethernet ports or an integral wireless access point .