Search results
Results from the WOW.Com Content Network
The conversion factor is 10 8 maxwell per weber, since flux is the integral of field over an area, area having the units of the square of distance, thus 10 4 G/T (magnetic field conversion factor) times the square of 10 2 cm/m (linear distance conversion factor). 10 8 Mx/Wb = 10 4 G/T × (10 2 cm/m) 2.
The prefix kilo, for example, implies a factor of 1000 (10 3), and the prefix milli implies a factor of 1/1000 (10 −3). Thus, a kilometre is a thousand metres, and a milligram is one thousandth of a gram.
Typically, a class specifies accuracy at a number of points, with the absolute accuracy at lower values being better than the nominal "percentage of full scale" accuracy. Accuracy classes such as IEC's 0.15s are a 'special' high accuracy class.
Decimalisation or decimalization (see spelling differences) is the conversion of a system of currency or of weights and measures to units related by powers of 10.. Most countries have decimalised their currencies, converting them from non-decimal sub-units to a decimal system, with one basic currency unit and sub-units that are valued relative to the basic unit by a power of 10, most commonly ...
One part per billion (ppb) denotes one part per 1,000,000,000 (10 9) parts, and a value of 10 −9. This is equivalent to about three seconds out of a century. One part per trillion (ppt) denotes one part per 1,000,000,000,000 (10 12) parts, and a value of 10 −12. This is equivalent to about thirty seconds out of every million years.
The percent value is computed by multiplying the numeric value of the ratio by 100. For example, to find 50 apples as a percentage of 1,250 apples, one first computes the ratio 50 / 1250 = 0.04, and then multiplies by 100 to obtain 4%. The percent value can also be found by multiplying first instead of later, so in this example, the 50 ...
The most commonly used derived unit is the millilitre, defined as one-thousandth of a litre, and also often referred to by the SI derived unit name "cubic centimetre". It is a commonly used measure, especially in medicine, cooking and automotive engineering. Other units may be found in the table below, where the more often used terms are in bold.
Young's modulus is commonly measured in the International System of Units (SI) in multiples of the pascal (Pa) and common values are in the range of gigapascals (GPa). Examples: Rubber (increasing pressure: length increases quickly, meaning low ) Aluminium (increasing pressure: length increases slowly, meaning high )