Search results
Results from the WOW.Com Content Network
Drainage gradient (DG) is a term in road design, defined as the combined slope due to road surface cross slope (CS) and longitudinal slope (hilliness). Although the term may not be used, the concept is also used in roof design and landscape architecture. If the drainage gradient is too low, rain and melt water drainage will be insufficient.
Invert level affects flow from drainage pipes In civil engineering , the invert level is the base interior level of a pipe, trench or tunnel ; it can be considered the "floor" level. [ 1 ] The invert is an important datum for determining the functioning or flowline of a piping system.
Drainage density is a quantity used to describe physical parameters of a drainage basin. First described by Robert E. Horton , drainage density is defined as the total length of channel in a drainage basin divided by the total area, represented by the following equation:
the design drain spacing (L) can be found from the equation in dependence of the drain depth (Dd) and drain radius (r). Drainage criteria One would not want the water table to be too shallow to avoid crop yield depression nor too deep to avoid drought conditions. This is a subject of drainage research.
Cross slope, cross fall or camber is a geometric feature of pavement surfaces: the transverse slope with respect to the horizon. It is a very important safety factor. Cross slope is provided to provide a drainage gradient so that water will run off the surface to a drainage system such as a street gutter or ditch.
For such drainage systems to work properly it is crucial that neutral air pressure be maintained within all pipes, allowing free gravity flow of water and sewage through drains. It is critical that a sufficient fall gradient (downward slope) be maintained throughout the drain pipes to keep liquids and entrained solids flowing freely from a ...
In that case, earthwork software is principally used to calculate cut and fill volumes which are then used for producing material and time estimates. Most products offer additional functionality such as the ability to takeoff terrain elevation from plans (using contour lines and spot heights ); produce shaded cut and fill maps; produce cross ...
It uses a combination of the energy, momentum, and continuity equations to determine water depth with a given a friction slope (), channel slope (), channel geometry, and also a given flow rate. In practice, this technique is widely used through the computer program HEC-RAS , developed by the US Army Corps of Engineers Hydrologic Engineering ...