enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Variable-length intake manifold - Wikipedia

   en.wikipedia.org/wiki/Variable-length_intake...

   Fiat – Controlled High Turbulence (1989–92, Fiat Croma CHT), StarJet engine, dubbed Port Deactivation (PDA), Variable Intake System on the 131HP 1.8 16V and on the 155 HP 2.0 20V Pratola Serra engine. Ford — Dual-Stage Intake (DSI), on their Duratec 2.5 and 3.0-litre V6s, and it was also found on the Yamaha V6 in the Taurus SHO.

3. Ford Duratorq engine - Wikipedia

   en.wikipedia.org/wiki/Ford_Duratorq_engine

   Introduced for the Thailand-built 2007 Ford Ranger (J97U) is a 2.5 L diesel engine. This truck is a clone of the Mazda B-Series and thus the engine is a Mazda engine. It has a bore and a stroke of 93 mm × 92 mm (3.66 in × 3.62 in). The engine has no commonality to Ford's "Puma" engine or VM Motori.

4. Diesel cycle - Wikipedia

   en.wikipedia.org/wiki/Diesel_cycle

   However, a real diesel engine will be more efficient overall since it will have the ability to operate at higher compression ratios. If a petrol engine were to have the same compression ratio, then knocking (self-ignition) would occur and this would severely reduce the efficiency, whereas in a diesel engine, the self ignition is the desired ...

5. Inlet manifold - Wikipedia

   en.wikipedia.org/wiki/Inlet_manifold

   Carburetors used as intake runners A cutaway view of the intake of the original Fordson tractor (including the intake manifold, vaporizer, carburetor, and fuel lines). An inlet manifold or intake manifold (in American English) is the part of an internal combustion engine that supplies the fuel/air mixture to the cylinders. [1]

6. Cylinder head porting - Wikipedia

   en.wikipedia.org/wiki/Cylinder_head_porting

   The graph above shows the intake runner pressure over 720 crank degrees of an engine with a 7-inch (180 mm) intake port/runner running at 4500 rpm, which is its torque peak (close to maximum cylinder filling and BMEP for this engine). The two pressure traces are taken from the valve end (blue) and the runner entrance (red).

7. Swirl flap - Wikipedia

   en.wikipedia.org/wiki/Swirl_flap

   Swirl flap principle in a four-valve engine. A swirl flap is a small butterfly valve fitted to four-stroke internal combustion engines with at least two intake valves.It is installed inside or just before one of a cylinder's two intake ports, allowing to throttle its intake port's air flow, causing a swirl in the other intake port not fitted with a swirl flap.