enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Riser clamp - Wikipedia

   en.wikipedia.org/wiki/Riser_clamp

   The copper pipe penetration is firestopped with firestop mortar. Riser clamp for a standpipe through-penetration firestop inside a fire hose cabinet under construction. A riser clamp is a type of hardware used by mechanical building trades for pipe support in vertical runs of piping (risers) at each floor level. The devices are placed around ...

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life. [ 21 ] : 149 [ 18 ] : 71 Optionally, the entire rubber sleeve may be jacketed with thin sheet metal, to provide extra stiffness, durability, and resistance to accidental ...

4. Pipe clamp - Wikipedia

   en.wikipedia.org/wiki/Pipe_clamp

   A pipe clamp is a type of clamp often employed in piping, woodworking, and cabinet shops. Pipe clamps for woodwork or cabinet shops are usually composed of commercially manufactured clamp heads or "jaws" and a length of common threaded pipe. [1] [2] The capacity of the clamp is determined by the length of the pipe used.

5. Copper tubing - Wikipedia

   en.wikipedia.org/wiki/Copper_tubing

   While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a nominal 3 ⁄ 4 inch copper pipe in the U.S. and Canada has measured diameters of 0.875 inch outside and ...

6. Compression fitting - Wikipedia

   en.wikipedia.org/wiki/Compression_fitting

   A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect

7. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   The history of copper pipe is similar. In the 1930s, the pipe was designated by its internal diameter and a 1 ⁄ 16-inch (1.6 mm) wall thickness. Consequently, a 1-inch (25 mm) copper pipe had a 1 + 1 ⁄ 8-inch (28.58 mm) outside diameter. The outside diameter was the important dimension for mating with fittings.