Search results
Results from the WOW.Com Content Network
So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths). (Decimal places for .25, .5, and .75 are shown to thousandths [.250, .500, .750], which is how machinists usually think ...
Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.
25.4 μm. A thousandth of an inch is a derived unit of length in a system of units using inches. Equal to 1000 of an inch, a thousandth is commonly called a thou / ˈθaʊ / (used for both singular and plural) or, particularly in North America, a mil (plural mils ). The words are shortened forms of the English and Latin words for "thousand ...
Sizes that may interchange, depending on the precision needed, include 2 mm (close to 5 ⁄ 64 inch (1.98 mm)), 4 mm (close to 5 ⁄ 32 inch (3.97 mm)) and 8 mm (close to 5 ⁄ 16 inch (7.94 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
linje – "line", after 1863 1⁄10 tum, 2.96 mm (0.117 in). Before that, 1⁄12 tum or 2.06 mm. mil – "mile", also lantmil. From 1699, defined as a unity mile of 18 000 alnar or 10.69 km (6.64 mi). The unified mile was meant to define the suitable distance between inns. After the 1889 metric conversion the Swedish mil is defined as exactly ...
The 7.62 mm designation refers to the internal diameter of the barrel at the lands (the raised helical ridges in rifled gun barrels). The actual bullet caliber is often 7.82 mm (0.308 in), although Soviet weapons commonly use a 7.91 mm (0.311 in) bullet, as do older British ( .303 British) and Japanese ( 7.7×58mm Arisaka) cartridges.
While modern firearms are generally referred to by the name of the cartridge the gun is chambered for, they are still categorized together based on bore diameter. For example, a firearm might be described as a "30 caliber rifle", which could accommodate any of a wide range of cartridges using a roughly 0.30 inches (7.6 mm) projectile; or as a "22 rimfire", referring to any rimfire firearms ...