Search results
Results from the WOW.Com Content Network
Ethernet flow control. Ethernet flow control is a mechanism for temporarily stopping the transmission of data on Ethernet family computer networks. The goal of this mechanism is to avoid packet loss in the presence of network congestion . The first flow control mechanism, the pause frame, was defined by the IEEE 802.3x standard.
Flow control (data) In data communications, flow control is the process of managing the rate of data transmission between two nodes to prevent a fast sender from overwhelming a slow receiver. Flow control should be distinguished from congestion control, which is used for controlling the flow of data when congestion has actually occurred. [1]
In computer networking, a flit ( flow control unit or flow control digit) is a link-level atomic piece that forms a network packet or stream. [1] The first flit, called the header flit holds information about this packet's route (namely the destination address) and sets up the routing behavior for all subsequent flits associated with the packet ...
Wormhole flow control, also called wormhole switching or wormhole routing, is a system of simple flow control in computer networking based on known fixed links. It is a subset of flow control methods called Flit-Buffer Flow Control. [1] : . Chapter 13.2.1. Switching is a more appropriate term than routing, as "routing" defines the route or path ...
Transport layer (4) RFC (s) RFC 9293. The Transmission Control Protocol ( TCP) is one of the main protocols of the Internet protocol suite. It originated in the initial network implementation in which it complemented the Internet Protocol (IP). Therefore, the entire suite is commonly referred to as TCP/IP. TCP provides reliable, ordered, and ...
In packet switching networks, traffic flow, packet flow or network flow is a sequence of packets from a source computer to a destination, which may be another host, a multicast group, or a broadcast domain. RFC 2722 defines traffic flow as "an artificial logical equivalent to a call or connection." [1] RFC 3697 defines traffic flow as "a ...
Software flow control. Software flow control is a method of flow control used in computer data links, especially RS-232 serial. It uses special codes, transmitted in-band, over the primary communications channel. These codes are generally called XOFF and XON (from "transmit off" and "transmit on", respectively).
OpenFlow allows direct access to and manipulation of the forwarding plane of network devices such as switches and routers, both physical and virtual (hypervisor-based). It is the absence of an open interface to the forwarding plane that has led to the characterization of today's networking devices as monolithic, closed, and mainframe-like.