enow.com Web Search

  1. Ads

    related to: washer dimensions in mm

Search results

  1. Results from the WOW.Com Content Network
  2. Washer (hardware) - Wikipedia

    en.wikipedia.org/wiki/Washer_(hardware)

    Washers of standard metric sizes equivalent to BS4320 Form A are listed in the table below. Measurements in the table refer to the dimensions of the washers as described by the drawing. Specifications for standard metric flat washers were known as DIN 125 (withdrawn) and replaced with ISO 7089.

  3. List of DIN standards - Wikipedia

    en.wikipedia.org/wiki/List_of_DIN_standards

    Round washers for high-strength structural steel bolting: Withdrawn: ... grid 2.54 mm; dimensions of type M; survey of special contracts for use with type M:

  4. British Association screw threads - Wikipedia

    en.wikipedia.org/wiki/British_Association_screw...

    The major diameter is given by 6p 1.2, [4]: 12 rounded to two significant figures in mm and the hex head size (across the flats) is 1.75 times the major diameter. BA sizes are specified by the following British Standards :

  5. Width across flats - Wikipedia

    en.wikipedia.org/wiki/Width_across_flats

    A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

  6. British Standard Pipe - Wikipedia

    en.wikipedia.org/wiki/British_Standard_Pipe

    In the modern standard metric version, it is simply a size number, where listed diameter size is the major outer diameter of the external thread. For a taper thread, it is the diameter at the "gauge length" (plus/minus one thread pitch) from the small end of the thread.

  7. United States Standard thread - Wikipedia

    en.wikipedia.org/wiki/United_States_Standard_thread

    United States Standard thread (USS thread), also known as Sellers Standard thread, [1] Franklin Institute thread [1] and American Standard thread, [2] is a standard for inch based threaded fasteners and washers. [3] The USS standard is no longer supported. It, together with the SAE fastener standard, was incorporated into the Unified Thread ...

  8. British Standard Whitworth - Wikipedia

    en.wikipedia.org/wiki/British_Standard_Whitworth

    BA threads have diameters of 6 mm (0BA) and smaller, and were and still are particularly used in precision machinery. The Whitworth 55° angle remains commonly used today worldwide in form of the 15 British standard pipe threads defined in ISO 7, which are commonly used in water supply, cooling, pneumatics, and hydraulic systems.

  9. Washer pitching - Wikipedia

    en.wikipedia.org/wiki/Washer_pitching

    Washer pits and boxes vary in size and shape, but a standard for one-hole washers is 16 by 16 by 4 inches (410 mm × 410 mm × 100 mm), with a cylindrically-shaped cup (4 + 1 ⁄ 2 in [110 mm] in diameter and 5 in [130 mm] in height) located in its upper surface. Boxes are placed approximately 20 feet (6.1 m) away from each other, a distance ...

  1. Ads

    related to: washer dimensions in mm