Search results
Results from the WOW.Com Content Network
A turbo generator is an electric generator connected to the shaft of a turbine (water, steam, or gas) for the generation of electric power. [ note 1 ] Large steam-powered turbo generators provide the majority of the world's electricity and are also used by steam-powered turbo-electric ships.
An example of a wind turbine, this 3 bladed turbine is the classic design of modern wind turbines Wind turbine components : 1-Foundation, 2-Connection to the electric grid, 3-Tower, 4-Access ladder, 5-Wind orientation control (Yaw control), 6-Nacelle, 7-Generator, 8-Anemometer, 9-Electric or Mechanical Brake, 10-Gearbox, 11-Rotor blade, 12-Blade pitch control, 13-Rotor hub
Closed-cycle gas turbine schematic C compressor and T turbine assembly w high-temperature heat exchanger ʍ low-temperature heat exchanger ~ mechanical load, e.g. electric generator. A closed-cycle gas turbine is a turbine that uses a gas (e.g. air, nitrogen, helium, argon, [1] [2] etc.) for the working fluid as part of a closed thermodynamic ...
Diagram of a steam turbine generator system. The control of a turbine with a governor is essential, as turbines need to be run up slowly to prevent damage and some applications (such as the generation of alternating current electricity) require precise speed control. [26]
Diagram of a disk MHD generator showing current flows. The third and, currently, the most efficient design is the Hall effect disc generator. This design currently holds the efficiency and energy density records for MHD generation. A disc generator has fluid flowing between the center of a disc, and a duct wrapped around the edge.
U.S. NRC image of a modern steam turbine generator (STG). In electricity generation, a generator [1] is a device that converts motion-based power (potential and kinetic energy) or fuel-based power (chemical energy) into electric power for use in an external circuit.
The bearings have to be leak-tight. A hermetic seal, usually a liquid seal, is employed; a turbine oil at pressure higher than the hydrogen inside is typically used. A metal, e.g. brass, ring is pressed by springs onto the generator shaft, the oil is forced under pressure between the ring and the shaft; part of the oil flows into the hydrogen side of the generator, another part to the air side.
The propelling nozzle converts a gas turbine or gas generator into a jet engine. Power available in the gas turbine exhaust is converted into a high speed propelling jet by the nozzle. The power is defined by typical gauge pressure and temperature values for a turbojet of 20 psi (140 kPa) and 1,000 °F (538 °C). [18]