Search results
Results from the WOW.Com Content Network
For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...
Cords connecting to an RJ11 interface require a 6P2C connector. Nevertheless, cords sold as RJ11 often use 6P4C connectors (six position, four conductor) with four wires. Two of the six possible contact positions connect tip and ring, and the other two conductors are unused. RJ11 is commonly used to connect DSL modems to the customer line.
The connector is also used in other telecommunications connections, including ISDN and T1. Where building network and telephone wiring is pre-installed, the center (blue) pair is often used to carry telephony signals. While this allows an RJ11 plug to connect, it may damage the modular jack; an approved converter prevents damage.
Perhaps the most comprehensively known and most discussed feature of ANSI/TIA-568 is the definition of the pin-to-pair assignments, or pinout, between the pins in a connector (a plug or a socket) and the wires in a cable. Pinouts are critical because cables do not function if the pinouts at their two ends aren't correctly matched.
Typically it will have a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the line, unlike RJ11, which uses pins 3 and 4).
Likewise in the office you're likely to have a "digital phone system" running over the RJ-45 structured cabling; ie another "digital" system on the "digital" connector. So no surprise the entire RJ connector series is seen as "digital" really. 86.16.135.53 10:53, 28 October 2006 (UTC) We really need to keep RJ11 intact.
In addition to the standard Swedish plugs and sockets, RJ11 connectors are quite common, especially in offices. Even 8P8C modular telephone sockets can be found. Most telephone equipment sold in Sweden today has RJ11 sockets and corresponding cables with 6P4C plugs on each end and an adaptor from RJ11 to SS 455 15 50 sockets. The Swedish ...
However, there is room for confusion. The PIC data sheets show an inverted socket and do not provide a pictorial view of pinouts so it is unclear what side of the socket Pin 1 is located on. The illustration provided here is untested but uses the phone industry standard pinout (the RJ11 plug/socket was original developed for wired desktop phones).