Search results
Results from the WOW.Com Content Network
DisplayPort connector A DisplayPort port (top right) on a laptop from 2010, near an Ethernet port (center) and a USB port (bottom right). DisplayPort (DP) is a proprietary [a] digital display interface developed by a consortium of PC and chip manufacturers and standardized by the Video Electronics Standards Association (VESA).
Display Data Channel (DDC) is a collection of protocols for digital communication between a computer display and a graphics adapter that enable the display to communicate its supported display modes to the adapter and that enable the computer host to adjust monitor parameters, such as brightness and contrast.
It defines a new license-free, royalty-free, digital audio/video interconnect, intended to be used primarily between a computer and its display monitor, or a computer and a home-theater system. The video signal is not compatible with DVI or HDMI , but a DisplayPort connector can pass these signals through.
It is primarily used to connect a video source to a display device such as a computer monitor. It can also carry audio, USB, and other forms of data. DisplayPort is backward compatible with other interfaces such as HDMI and DVI through the use of active or passive adapters. Male Mini DisplayPort plug Mini DisplayPort
The second byte is an opcode which specifies the operation to be performed, and the number and meaning of following parameter bytes. For example, a user press on a remote control will generate a 3-byte frame: a header byte, a <User Control Pressed> opcode (0x44), and an operand byte identifying the button. Including the initial idle time and ...
VCRs, DVD recorders, etc. act as a "pass-through" for composite video and S-video, though sometimes they act as an RF modulator for use on Channel 3. Tape monitor features allow an AV receiver (sometime the recording device itself) to act as a "pass-through" for audio.
Problems may arise if there is an inconsistency between the KVM's specifications and the monitor's, such as not being able to select desired resolutions. Pass-through: the KVM switch attempts to make communication between the monitor and the system transparent. However, it may fail to do so in the following ways:
The data is transmitted via the cable connecting the display and the graphics card; VGA, DVI, DisplayPort and HDMI are supported. [citation needed] The EDID is often stored in the monitor in the firmware chip called serial EEPROM (electrically erasable programmable read-only memory) and is accessible via the I²C-bus at address 0x50. The EDID ...