Search results
Results from the WOW.Com Content Network
ping is a computer network administration software utility used to test the reachability of a host on an Internet Protocol (IP) network. It is available in a wide range of operating systems – including most embedded network administration software.
In computer programming, a usage message or help message is a brief message displayed by a program that utilizes a command-line interface for execution. This message usually consists of the correct command line usage for the program and includes a list of the correct command-line arguments or options acceptable to said program.
The advantages of PathPing over ping and traceroute are that each node is pinged as the result of a single command, and that the behavior of nodes is studied over an extended time period, rather than the default ping sample of four messages or default traceroute single route trace. The disadvantage is that it takes a total of 25 seconds per hop ...
In computing, traceroute and tracert are diagnostic command-line interface commands for displaying possible routes (paths) and transit delays of packets across an Internet Protocol (IP) network. The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination.
Paping (pronounced pah ping) is a computer network administration utility used to test the reachability of a host on an Internet Protocol (TCP/IP) network and to measure the time it takes to connect to a specified port. The name is a play on the word ping, another computer network administration utility.
This command is often used to obtain the IP of an abusive user to more effectively perform a ban. It is unclear what, if any, privileges are required to execute this command on a server. This command is not formally defined by an RFC, but is in use by some IRC daemons. Support is indicated in a RPL_ISUPPORT reply (numeric 005) with the USERIP ...
RTT is a measure of the amount of time taken for an entire message to be sent to a destination and for a reply to be sent back to the sender. The time to send the message to the destination in its entirety is known as the network latency, and thus RTT is twice the latency in the network plus a processing delay at the destination.
The CTCP PING command works by sending an (often) integer argument (a timestamp) to a target client, the target client then responds by supplying exactly the same numerical parameter. The difference between the original timestamp and the current timestamp is calculated, with the result being displayed to the user that initiated the CTCP PING .