Search results
Results from the WOW.Com Content Network
The reverse flow head was ideally suited to a production carbureted engine due to its low rpm performance and ease of manufacture. The design could be modified for high performance by porting (in particular siamese) and isolating the inlet manifold from the exhaust header.
The Chrysler Slant-Six is the popular name for an overhead valve inline-6 engine produced by Chrysler Motors between 1959 and 2000. Featuring a reverse-flow cylinder head and cylinder bank inclined at a 30-degree angle from vertical, it was introduced in 170 cu in (2.8 L) and 225 cu in (3.7 L) displacements for the 1960 model year.
A crossflow head gives better performance than a Reverse-flow cylinder head (though not as good as a uniflow), but the popular explanation put forward for this — that the gases do not have to change direction and hence are moved into and out of the cylinder more efficiently — is a simplification since there is no continuous flow because of valve opening and closing.
The M-105 was the first Klimov V-12 engine design to use reverse-flow cylinder heads, forcing the induction system to be placed on the outside of the cylinder banks, with the exhaust system also exiting from the outboard side, with twin sets of "siamesed" exhaust ports adjacent to each other. About 129,000 M-105 and its variants were built.
The engine is now referred to as the pre-crossflow Kent, in reverse-flow cylinder head configuration with both the inlet and exhaust being on the same side of the head. Applications: Ford Anglia; Ford Cortina; Ford Consul Classic and Consul Capri. Ford Corsair; 107E Ford Prefect; Autocars Sussita; Lotus Seven S2; Marcos 1500 GT
The Ford Model T used a 177 cu in (2.9 L) sidevalve, reverse-flow cylinder head inline 4-cylinder engine. It was primarily a gasoline engine. It produced 20 hp (14.9 kW) for a top speed of 45 mph (72 km/h). It was built in-unit with the Model T's novel transmission (a planetary design), sharing the same lubricating oil.
[14] It features a compacted graphite iron (CGI) block for greater strength and reduced weight, reverse flow aluminum cylinder heads (the exhaust ports are located in the lifter valley) with dual water jackets, six head bolts per cylinder, and 29,000 psi (1,999 bar) high-pressure common rail Bosch fuel system. The system delivers up to five ...
Unlike most other car makers at the time, Buick had been using a valve-in-head/OHV overhead valve reverse-flow cylinder head design or I-head since their inception and continued this practice in their straight-eight designs.