enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hairpin technology - Wikipedia

   en.wikipedia.org/wiki/Hairpin_technology

   [6] [8] [5] There are three technologies for bending hairpin wires: U-Pin, in which hairpin wires have a shape resembling a U, I-Pin, with wires resemling an I, and Continuous Hairpin, also called continuous wave, in which a single wire is bent into a serpentine shape up to several meters long. U-Pin technology is the most common of these. [9] [10]

3. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   The tips of roll pin punches are not flat and should never be used on regular solid pins. If a roll pin punch is used on a solid pin, it will mar or mark the pin. If the end of a roll pin punch is damaged or deformed, it should be discarded. It is virtually impossible to regrind the tip of the roll pin punch and properly shape the center ...

4. Automatic center punch - Wikipedia

   en.wikipedia.org/wiki/Automatic_center_punch

   The Frey mechanism uses a steel ball and an out-of-flat end for the intermediate pin to force the intermediate pin to cock at reset. This means the intermediate spring doesn't need a special end, but the high stresses at the contact with the steel ball can lead to brinelling of the intermediate pin end or the top of the punch by the ball.

5. INCA (software) - Wikipedia

   en.wikipedia.org/wiki/INCA_(Software)

   A host of functions required for ECU software calibration, such as interface-dependent calibration methods, calibration data management, measurement data visualization and analysis, ECU programming, vehicle bus monitoring, as well as remote control through standard interfaces, are part of the product's functional complement.

6. Data link connector - Wikipedia

   en.wikipedia.org/wiki/Data_link_connector

   The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...

7. RPD machine gun - Wikipedia

   en.wikipedia.org/wiki/RPD_machine_gun

   The cleaning kit consists of a rectangular metal clam-shell case that typically contains the following tools and spare parts: pin punch (used for disassembling the bolt), cleaning jag, multi-tool (includes screwdriver, small and large wrenches used for adjusting the front sight and gas system, respectively, and a notch for installing and ...

8. Screw extractor - Wikipedia

   en.wikipedia.org/wiki/Screw_extractor

   A screw extractor held in a tap wrench. A screw extractor is a tool for removing broken or seized screws.There are two types: one has a spiral flute structure, commonly called an easy out after the trademarked name EZ-Out; [clarification needed] the other has a straight flute structure.

9. Crankpin - Wikipedia

   en.wikipedia.org/wiki/Crankpin

   A crankpin or crank pin, also known as a rod bearing journal, [1] is a mechanical device in an engine which connects the crankshaft to the connecting rod for each cylinder. It has a cylindrical surface, to allow the crankpin to rotate relative to the "big end" of the connecting rod.