Search results
Results from the WOW.Com Content Network
Upon completion of the service routine, the RTI instruction would be used to return control to the program that made the operating system call. Note that the signature for BRK may be any value, whereas the signature for COP should be limited to the range $00-$7F. [2] The use of BRK and/or COP to request an operating system service means user ...
In computer systems programming, an interrupt handler, also known as an interrupt service routine or ISR, is a special block of code associated with a specific interrupt condition. Interrupt handlers are initiated by hardware interrupts, software interrupt instructions, or software exceptions , and are used for implementing device drivers or ...
An interrupt vector table (IVT) is a data structure that associates a list of interrupt handlers with a list of interrupt requests in a table of interrupt vectors. Each entry of the interrupt vector table, called an interrupt vector, is the address of an interrupt handler (also known as ISR). While the concept is common across processor ...
In traditional CPU architecture, external interrupt lines are fed to an on-chip interrupt controller and are serviced by one or more interrupt service routines. When an interrupt occurs, the interrupt controller suspends normal CPU processing and saves internal state (typically on the stack), then vectors to the designated interrupt service ...
Hardware interrupts may be mapped to any of the vectors by way of a programmable interrupt controller. On the 80286 and later, the size and locations of the IVT can be changed in the same way as it is done with the IDT (Interrupt descriptor table) in protected mode (i.e., via the LIDT (Load Interrupt Descriptor Table Register) instruction ...
When an I/O device interrupts a program, it places the address of its vector on the bus to indicate which service routine should take control. The lowest vectors are service routines to handle various types of trap. Traps occur on some program errors, such as an attempt to execute an undefined instruction; and also when the program executes an ...
The IRR specifies which interrupts are pending acknowledgement, and is typically a symbolic register which can not be directly accessed. The ISR register specifies which interrupts have been acknowledged, but are still waiting for an end of interrupt (EOI). The IMR specifies which interrupts are to be ignored and not acknowledged.
Automated Interrupt Prologue – adds hardware to save and update system status before the interrupt handling routine; Automated Interrupt Epilogue – restores the system state previously stored in the stack for returning from the interrupt. Interrupt Chaining – supports the service of pending interrupts without the need to exit the initial ...