enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Pulley - Wikipedia

   en.wikipedia.org/wiki/Pulley

   Sheave without a rope. A pulley is a wheel on an axle or shaft enabling a taut cable or belt passing over the wheel to move and change direction, or transfer power between itself and a shaft. A sheave or pulley wheel is a pulley using an axle supported by a frame or shell (block) to guide a cable or exert force.

3. Belt (mechanical) - Wikipedia

   en.wikipedia.org/wiki/Belt_(mechanical)

   Belts are looped over pulleys and may have a twist between the pulleys, and the shafts need not be parallel. In a two pulley system, the belt can either drive the pulleys normally in one direction (the same if on parallel shafts), or the belt may be crossed, so that the direction of the driven shaft is reversed (the opposite direction to the ...

4. Sprocket - Wikipedia

   en.wikipedia.org/wiki/Sprocket

   16 tooth sprocket. Do = Sprocket diameter. Dp = Pitch diameter A sprocket and roller chain. A sprocket, [1] sprocket-wheel [2] or chainwheel is a profiled wheel with teeth that mesh with a chain, rack or other perforated or indented material. [3] [4] The name 'sprocket' applies generally to any wheel upon which radial projections engage a chain ...

5. Conveyor pulley - Wikipedia

   en.wikipedia.org/wiki/Conveyor_pulley

   The end disk and hub may be one piece. The locking assembly may also be replaced with a hub and bushing on lower tension pulleys. The shell is also referred to as the rim in some parts of the world. The pulley shaft is typically sized following CEMA B105.1 in the Americas or AS 1403 in Australia.

6. Block and tackle - Wikipedia

   en.wikipedia.org/wiki/Block_and_tackle

   A block is a set of pulleys or sheaves mounted on a single frame. An assembly of blocks with a rope threaded through the pulleys is called tackle. The process of threading ropes or cables through blocks is called "reeving", and a threaded block and tackle is said to have been "rove". [7]

7. Toothed belt - Wikipedia

   en.wikipedia.org/wiki/Toothed_belt

   They are made as flexible belts with teeth moulded onto their inner surface. The belts run over matching toothed pulleys or sprockets. [5] [6] [7] When correctly tensioned, these type of belts have no slippage, and are often used to transfer motion for indexing or timing purposes (hence their name). They are often used in lieu of chains or ...