enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. IEC 60320 - Wikipedia

   en.wikipedia.org/wiki/IEC_60320

   A variety of different kinds of IEC 60320 plugs and sockets. IEC 60320 Appliance couplers for household and similar general purposes [1] is a set of standards from the International Electrotechnical Commission (IEC) specifying non-locking connectors for connecting power supply cords to electrical appliances of voltage not exceeding 250 V (a.c.) and rated current not exceeding 16 A. [1 ...

3. Bi-wiring - Wikipedia

   en.wikipedia.org/wiki/Bi-wiring

   Bottom: bi-wiring. Loudspeaker bi-wired using banana plugs. Bi-wiring is a means of connecting a loudspeaker to an audio amplifier, primarily used in hi-fi systems. Normally, there is one pair of connectors on a loudspeaker and a single cable (two conductors) runs from the amplifier output to the terminals at the loudspeaker housing.

4. AC power plugs and sockets: British and related types

   en.wikipedia.org/wiki/AC_power_plugs_and_sockets:...

   In fact the fuse is there to protect the flexible cord between the plug and the appliance under fault conditions [50] [51] (typical British ring circuits can deliver more current than appliance flexible power cords can handle). BS 1363 plugs are required to carry a cartridge fuse, [52] which must conform to BS 1362.

5. Bi-amping and tri-amping - Wikipedia

   en.wikipedia.org/wiki/Bi-amping_and_tri-amping

   Bi-amping is the use of two channels of amplification to power each loudspeaker within an audio system. Tri-amping is the practice of connecting three channels of amplification to a loudspeaker unit: one to power the bass driver ( woofer ), one to power the mid-range and the third to power the treble driver ( tweeter ).

6. AC power plugs and sockets - Wikipedia

   en.wikipedia.org/wiki/AC_power_plugs_and_sockets

   Ratings of NEMA 5-15 (type B) plug marked on the label (left: 7 A 125 V), engagement face, and IEC 60320 C13 connector at the appliance end of the cord (centre, right: both 10 A 125 V) Plugs and power cords have a rated voltage and current assigned to them by the manufacturer. Using a plug or power cord that is inappropriate for the load may be ...

7. Power cord - Wikipedia

   en.wikipedia.org/wiki/Power_cord

   A power cord, line cord, or mains cable is an electrical cable that temporarily connects an appliance to the mains electricity supply via a wall socket or extension cord. The terms are generally used for cables using a power plug to connect to a single-phase alternating current power source at the local line voltage (generally 100 to 240 volts ...

8. Electrical wiring in North America - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_North...

   The neutral wire is identified by gray or white insulated wire, perhaps using stripes or markings. With lamp cord wire the ribbed wire is the neutral, and the smooth wire is the hot. NEC 2008 400.22(f) allows surface marking with ridged, grooves or white stripes on the surface of lamp cord.

9. Electrical wiring - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring

   The first rubber-insulated cables for US building wiring were introduced in 1922 with US patent 1458803, Burley, Harry & Rooney, Henry, "Insulated electric wire", issued 1923-06-12, assigned to Boston Insulated Wire and Cable . These were two or more solid copper electrical wires with rubber insulation, plus woven cotton cloth over each ...