enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. 2009–2011 Toyota vehicle recalls - Wikipedia

   en.wikipedia.org/wiki/2009–2011_Toyota_vehicle...

   The 2009–11 Toyota vehicle recalls involved three separate but related recalls of automobiles by the Japanese manufacturer Toyota Motor Corporation, which occurred at the end of 2009 and the start of 2010. Toyota initiated the recalls, the first two with the assistance of the U.S. National Highway Traffic Safety Administration (NHTSA), after ...

3. Power steering - Wikipedia

   en.wikipedia.org/wiki/Power_steering

   Power steering is a system for reducing a driver's effort to turn a steering wheel of a motor vehicle, by using a power source to assist steering. [1]Hydraulic or electric actuators add controlled energy to the steering mechanism, so the driver can provide less effort to turn the steered wheels when driving at typical speeds, and considerably reduce the physical effort necessary to turn the ...

4. Kingpin (automotive part) - Wikipedia

   en.wikipedia.org/wiki/Kingpin_(automotive_part)

   The steering kingpin is held in place by the forked ends of a beam axle on a Ford Model T. The kingpin (also king-pin, king pin and k pin) [1] [2] is the main pivot in the steering mechanism of a car or other vehicle. The term is also used to refer to part of a fifth wheel coupling apparatus for a semi and its trailer or other load.

5. Serpentine belt - Wikipedia

   en.wikipedia.org/wiki/Serpentine_belt

   Serpentine belt (foreground) and dual vee belt (background) on a bus engine Belt tensioner providing pressure against the back of a serpentine belt in an automobile engine. A serpentine belt (or drive belt [1]) is a single, continuous belt used to drive multiple peripheral devices in an automotive engine, such as an alternator, power steering pump, water pump, air conditioning compressor, air ...

6. Steering knuckle - Wikipedia

   en.wikipedia.org/wiki/Steering_knuckle

   In a drive suspension, the knuckle has no spindle, but rather has a hub into which is affixed the bearings and shaft of the drive mechanism. The end of the drive mechanism would then have the necessary mounting studs for the wheel/tire and/or brake assembly. Therefore, the wheel assembly would rotate as the drive shaft (or half-shaft) dictates.

7. Caster angle - Wikipedia

   en.wikipedia.org/wiki/Caster_angle

   Caster angles over 7 degrees with radial tires are common. Power steering is usually necessary to overcome the jacking effect from the high caster angle. Some front-end alignment calls for different right-side and left-side caster. This is called cross caster, and the difference is called the spread.