Search results
Results from the WOW.Com Content Network
The "feeds" may be for the X-axis or the Z-axis (typically mm/rev or inch/rev for lathe work; sometimes measured as mm/min or inch/min). Notice that as the tool plunges closer to the workpiece's center, the same spindle speed will yield a decreasing surface (cutting) speed (because each rev represents a smaller circumferential distance, but ...
Fay automatic lathe, 1921. [1] Bullard Mult-Au-Matic, a vertical, multispindle automatic lathe, 1914. [2] In metalworking and woodworking, an automatic lathe is a lathe with an automatically controlled cutting process. Automatic lathes were first developed in the 1870s and were mechanically controlled.
Fay automatic lathe [1]. The Fay automatic lathe was an automatic lathe tailored to cutting workpieces that were mounted on centers (tools with pointed ends to accurately position a center-drilled workpiece about an axis, either directly or by using a mandrel).
Main page; Contents; Current events; Random article; About Wikipedia; Contact us
SFM is a combination of diameter and the velocity of the material measured in feet-per-minute as the spindle of a milling machine or lathe. 1 SFM equals 0.00508 surface meter per second (meter per second, or m/s, is the SI unit of speed). The faster the spindle turns, and/or the larger the diameter, the higher the SFM.
Universal Dividing heads: some manual indexing heads are equipped with a power drive provision. This allows the rotation of the dividing head to be connected to the table feed of the milling machine instead of using a hand crank. A set of change gears is provided to select the ratio between the table feed and rotation.
Facing on the lathe uses a facing tool to cut a flat surface perpendicular to the work piece's rotational axis. A facing tool is mounted into a tool holder that rests on the carriage of the lathe. The tool will then feed perpendicularly across the part's rotational axis as it spins in the jaws of the chuck.
When a cutting tool such as a drill bit or reamer is used, the feed is done with this leadscrew. The extendible portion of the tailstock is called the barrel, and usually has a Morse taper mount in the end of it to secure the drill or reamer. If the work is heavy, the drill may be further secured from turning with a lathe dog as shown in the photo.