Search results
Results from the WOW.Com Content Network
The 1960 Milliken MX1 Camber Car has a large negative camber. Camber angle is one of the angles made by the wheels of a vehicle; specifically, it is the angle between the vertical axis of a wheel and the vertical axis of the vehicle when viewed from the front or rear.
Camber is the angle which the vertical axis of the wheel makes with the vertical axis of the vehicle. This angle is very important for the cornering performance of the vehicles. Generally, a Camber around 0.5-2 degrees is given on the vehicles. Depending upon wheel orientation, Camber can be of three types. 1. Positive Camber
Self aligning torque , slip angle , and camber angle are also shown. Self aligning torque ( SAT ), also known as aligning torque or aligning moment ( Mz , moment about the z direction ), is the torque that a tire creates as it rolls along, which tends to steer it, i.e. rotate it around its vertical axis.
Camber is a complex property that can be more fully characterized by an airfoil's camber line, the curve Z(x) that is halfway between the upper and lower surfaces, and thickness function T(x), which describes the thickness of the airfoils at any given point. The upper and lower surfaces can be defined as follows:
An illustration of a wheel with negative camber. Camber is a measurement from the centerline of the wheel/tire relative to the road's surface. Negative camber is when the top of the wheel/tire angles inward toward the center of the vehicle. When done sparingly, negative camber greatly improves the handling characteristics of a vehicle.
If the top of the wheel is tilted outward, away from the body, the wheel is said to have positive camber; if the top is tilted inward, towards the body, it is said to have negative camber. Angled wheels are sometimes an intentional part of a vehicle's design, but most ordinary road vehicles are intended to have minimal or neutral camber (i.e ...
Of course things should be the same, left and right, for road cars. Camber affects steering because a tire generates a force towards the side that the top is leaning towards. This is called camber thrust. Additional front negative camber is used to improve the cornering ability of cars with insufficient camber gain.
When a wheel is set up to have some camber angle, the interaction between the tire and road surface causes the wheel to tend to want to roll in a curve, as if it were part of a conical surface (camber thrust). This tendency to turn increases the rolling resistance as well as increasing tire wear. A small degree of toe (toe-out for negative ...