Search results
Results from the WOW.Com Content Network
Graphic equalizer use leading to speaker damage is common — large amounts of bass boost and treble boost can distort music and damage loudspeaker drivers. [9] Ideally, the equalizer can be set once to compensate for the combination of the response of the speakers and the car's acoustic characteristics. [10]
For example, in Europe, for many years recordings required playback with a bass turnover setting of 250 to 300 Hz and a treble rolloff at 10,000 Hz ranging from 0 to −5 dB, or more. In the United States, practices varied and a tendency arose to use higher bass turnover frequencies, such as 500 Hz, as well as a greater treble rolloff such as ...
Equalization, or simply EQ, in sound recording and reproduction is the process of adjusting the volume of different frequency bands within an audio signal. The circuit or equipment used to achieve this is called an equalizer. [1] [2] Most hi-fi equipment uses relatively simple filters to make bass and treble adjustments. Graphic and parametric ...
Loudness compensation, or simply loudness, is a setting found on some hi-fi equipment that increases the level of the high and low frequencies. [1] This is intended to be used while listening at low-volume levels, to compensate for the fact that as the loudness of audio decreases, the ear's lower sensitivity to extreme high and low frequencies ...
There is a limit to the flexibility of such controls, and they are sometimes insufficient. If the degree of mis-match between microphones is great, simply increasing presence is not enough, and instead a sound engineer will use a graphic equalizer, sometimes several, each connected to an individual sound channel. [3]
Some more expensive bass amps have a parametric equalizer, which enables precise control of tone. The first amplifier stage is a preamplifier. It amplifies the audio signal to a level that can drive the power stage. The preamplifier also changes the tone of the signal; high preamp settings add overdrive.
Main indicates that high-pass filters are commonly used for directional microphones which have a proximity effect—a low-frequency boost for very close sources. This low-frequency boost commonly causes problems up to 200 or 300 Hz, but Main notes that he has seen microphones that benefit from a 500 Hz high-pass filter setting on the console. [5]
Threshold timing behavior is subject to attack and release settings (see below). When the signal level goes above threshold, compressor operation is delayed by the attack setting. For an amount of time determined by the release after the input signal has fallen below the threshold, the compressor continues to apply dynamic range compression.