enow.com Web Search

  1. Ad

    related to: m14x1.5 to m10x1.25 reducer

Search results

  1. Results from the WOW.Com Content Network
  2. ISO metric screw thread - Wikipedia

    en.wikipedia.org/wiki/ISO_metric_screw_thread

    A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...

  3. Barrel threads - Wikipedia

    en.wikipedia.org/wiki/Barrel_threads

    Typically, many rifles use thread diameters in the range between 25–27 mm (0.98–1.06 in). [citation needed] Many older rifles from the first half of the 20th century use a thread pitch around 2 mm (12.7 TPI), while many modern rifle use thread pitches around 1.5 mm (16.93 TPI). Fine threaded systems intended for hand tightening typically ...

  4. Concentric reducer - Wikipedia

    en.wikipedia.org/wiki/Concentric_reducer

    A concentric reducer is used to join pipe sections or tube sections on the same axis. [1] The concentric reducer is cone -shaped, and is used when there is a shift in diameter between pipes. [ 1 ] For example, when a 1" pipe transitions into a 3/4" pipe and the top or bottom of the pipe doesn't need to remain level. [ 2 ]

  5. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    A reducer reduces the pipe size from a larger to a smaller bore (inner diameter). Alternatively, reducer may refer to any fitting which causes a change in pipe diameter. [15] This change may be intended to meet hydraulic flow requirements of the system or adapt to existing piping of a different size. The reduction length is usually equal to the ...

  6. Eccentric reducer - Wikipedia

    en.wikipedia.org/wiki/Eccentric_reducer

    Eccentric reducers are used at the suction side of pumps to ensure air does not accumulate in the pipe. The gradual accumulation of air in a concentric reducer could result in a large bubble that could eventually cause the pump to stall or cause cavitation when drawn into the pump. Eccentric reducers exhibit a unique design with one side having ...

  7. Threaded insert - Wikipedia

    en.wikipedia.org/wiki/Threaded_insert

    TIME-SERT insert. A threaded insert, also known as a threaded bushing, is a fastener element that is inserted into an object to add a threaded hole. [1] They may be used to repair a stripped threaded hole, provide a durable threaded hole in a soft material, place a thread on a material too thin to accept it, mold or cast threads into a work piece thereby eliminating a machining operation, or ...

  8. Water reducer - Wikipedia

    en.wikipedia.org/wiki/Water_reducer

    Water reducers offer several advantages in their use, listed below: reduces the water content by 5-10%; decreases the concrete porosity; increases the concrete strength by up to 25% (as less water is required for the concrete mixture to remain workable) increases the workability (assuming the amount of free water remains constant)

  9. Pressure regulator - Wikipedia

    en.wikipedia.org/wiki/Pressure_regulator

    The distribution pressure is further reduced at a district regulator station, located at various points in the city, to below 60 psig. The final cut would occur at the end users location. Generally, the end user reduction is taken to low pressures ranging from 0.25 psig to 5 psig. Some industrial applications can require a higher pressure.

  1. Ad

    related to: m14x1.5 to m10x1.25 reducer