enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Lineman's pliers - Wikipedia

   en.wikipedia.org/wiki/Lineman's_pliers

   Lineman's pliers are used in the electrical trade to cut, straighten, and bend wire, and also to twist wires together when making splices. Lineman's can be used to strip wire and some types of cable, although wire strippers are more commonly used for this purpose as they can strip wire more quickly without damaging the conductors themselves.

3. Twist tie - Wikipedia

   en.wikipedia.org/wiki/Twist_tie

   The plastic, poly, or metallic paper twist ties withstand water better than the uncoated paper versions. Different sizes and strengths are used for different applications, from a small closure for a bag of bread to a large, heavy tie to hold unwieldy garden hoses in place. A twist tie with a broad paper covering may also be used for labeling.

4. Western Union splice - Wikipedia

   en.wikipedia.org/wiki/Western_union_splice

   Figure parts A–D show steps in forming a "short tie" Western Union splice. Figure parts E and F show two possible "long tie" variations. [2]The Western Union splice or lineman splice is a method of joining electrical cable, developed in the nineteenth century during the introduction of the telegraph and named for the Western Union telegraph company.

5. Rat-tail splice - Wikipedia

   en.wikipedia.org/wiki/Rat-tail_splice

   A rat-tail splice, also known as a twist splice or a pig-tail splice, is a basic electrical splice that can be done with both solid and stranded wire. It is made by taking two or more bare wires and wrapping them together symmetrically around the common axis of both wires. The bare splice can be insulated with electrical tape or by other means.

6. Diagonal pliers - Wikipedia

   en.wikipedia.org/wiki/Diagonal_pliers

   Diagonal pliers (also known as wire cutters or diagonal cutting pliers, or under many regional names) are pliers intended for the cutting of wire or small stock, rather than grabbing or turning. The plane defined by the cutting edges of the jaws intersects the joint rivet at an angle or "on a diagonal", giving pliers their name.

7. Electrical discharge machining - Wikipedia

   en.wikipedia.org/wiki/Electrical_discharge_machining

   The upper and lower diamond guides are usually accurate to 0.004 mm (0.16 mils), and can have a cutting path or kerf as small as 0.021 mm (0.83 mils) using Ø 0.02 mm (0.79 mils) wire, though the average cutting kerf that achieves the best economic cost and machining time is 0.335 mm (13.2 mils) using Ø 0.25 mm (9.8 mils) brass wire. The ...