enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. BS 1088 - Wikipedia

   en.wikipedia.org/wiki/BS_1088

   Face Veneer thickness-- For any three-ply construction, which applies to 3 and 4 mm material, each face veneer shall be not thinner than 1/8 of the total thickness of veneers assembled dry. Since the dry thicknesses of the boards are 3.6 and 4.6 respectively, we can assume that, for these thicknesses only, the face veneers will be as follows:

3. Medium density overlay panel - Wikipedia

   en.wikipedia.org/wiki/Medium_density_overlay_panel

   Medium density overlay panel, or MDO panel, is a paintable surface made of plywood with a weather-resistant resin overlay bonded to the wood by heat and pressure. The overlay, which has at least 27% resin content, [1] resists water, weather, wear and degradation. A similar product with a more rugged, smoother surface is called high density ...

4. Medium-density fibreboard - Wikipedia

   en.wikipedia.org/wiki/Medium-density_fibreboard

   The pressing cycle operates in stages, with the mat thickness being first compressed to around 1.5 times the finished board thickness, then compressed further in stages and held for a short period. This gives a board profile with zones of increased density, thus mechanical strength, near the two faces of the board and a less dense core. [9]

5. Plywood - Wikipedia

   en.wikipedia.org/wiki/Plywood

   [citation needed] At 3 ⁄ 8 inch (9.5 mm) thick, mahogany three-ply "wiggle board" or "bendy board" come in 4 by 8 feet (1.2 m × 2.4 m) sheets with a very thin cross-grain central ply and two thicker exterior plies, either long grain on the sheet, or cross grain. Wiggle board is often glued together in two layers once it is formed into the ...

6. Oriented strand board - Wikipedia

   en.wikipedia.org/wiki/Oriented_strand_board

   Oriented strand board (OSB) is a type of engineered wood, formed by adding adhesives and then compressing layers of wood strands (flakes) in specific orientations. It was invented by Armin Elmendorf in California in 1963. [ 1 ]

7. Fiberboard - Wikipedia

   en.wikipedia.org/wiki/Fiberboard

   Board is then cooled, trimmed, sanded and maybe veneered or laminated. UF resins are dominantly used in the MDF industry because of their low cost and fast curing characteristics. [ 2 ] However, pressures on the use of UF resins are mounting steadily due to potential problems associated with formaldehyde emission. [ 3 ]