Search results
Results from the WOW.Com Content Network
The GU24 fitting is intended to maintain the energy efficiency of the light by preventing an occupant from using an incandescent bulb instead of a CFL. Adapters to use incandescent bulbs in a GU24 fitting are illegal in the State of California as they would be a fire hazard in fixtures designed for the lower heat output of a CFL bulb.
Shown here will be fastened to this recessed, non-metallic box, then a cover plate is installed. This "double gang" (two unit) installation uses non-metallic-sheathed cable and twist-on wire connectors. In electrical wiring, a light switch is a switch most commonly used to operate electric lights, permanently connected equipment, or electrical ...
A 3-way lamp, also known as a tri-light, is a lamp that uses a 3-way light bulb to produce three levels of light in a low-medium-high configuration. A 3-way lamp requires a 3-way bulb and socket, and a 3-way switch. In 3-way incandescent light bulbs, each of the filaments operates at full voltage. Lamp bulbs with dual carbon filaments were ...
A lightbulb socket, lightbulb holder, light socket, lamp socket or lamp holder is a device which mechanically supports and provides electrical connections for a compatible electric lamp base. [1] Sockets allow lamps to be safely and conveniently replaced (re-lamping).
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
Historically, wiring installation requirements were less demanding in the age of knob-and-tube wiring than today. Compared to modern electrical wiring standards, these are the main technical shortcomings of knob-and-tube wiring methods: never included a safety grounding conductor
Plug and socket connectors are usually made up of a male plug (typically pin contacts) and a female socket (typically receptacle contacts). Often, but not always, sockets are permanently fixed to a device as in a chassis connector (see above) , and plugs are attached to a cable.
Some adapters for wall outlets use an Edison screw, allowing a light socket to become an ungrounded electrical outlet (such as to install Christmas lights temporarily via a porch light), or to make a pull-chain switch with two outlets, or to split it for two lamps. Another adapter can make a wall outlet into a lamp holder (lamp socket).