Search results
Results from the WOW.Com Content Network
The Individual Address Block (IAB) is an inactive registry which has been replaced by the MA-S (MAC address block, small), previously named OUI-36, and has no overlaps in addresses with the IAB [6] registry product as of January 1, 2014. The IAB uses an OUI from the MA-L (MAC address block, large) registry, previously called the OUI registry.
A broadcast address is a network address used to transmit to all devices connected to a multiple-access communications network. A message sent to a broadcast address may be received by all network-attached hosts. In contrast, a multicast address is used to address a specific group of devices, and a unicast address is used to address a single ...
In particular its specifications include an Address Resolution Protocol that can make dynamic address allocations. Dynamic reconfiguration of the hardware and software allow bus devices to be ‘hot-plugged’ and used immediately, without restarting the system. The devices are recognized automatically and assigned unique addresses.
One of the major improvements the PCI Local Bus had over other I/O architectures was its configuration mechanism. In addition to the normal memory-mapped and I/O port spaces, each device function on the bus has a configuration space, which is 256 bytes long, addressable by knowing the eight-bit PCI bus, five-bit device, and three-bit function numbers for the device (commonly referred to as the ...
The Internet Engineering Task Force (IETF) has reserved the IPv4 address block 169.254.0.0 / 16 (169.254.0.0 – 169.254.255.255) for link-local addressing. [1] The entire range may be used for this purpose, except for the first 256 and last 256 addresses (169.254.0.0 / 24 and 169.254.255.0 / 24), which are reserved for future use and must not be selected by a host using this dynamic ...
In earlier BIOSes, up to around the turn of the millennium, the POST would perform a thorough test of all devices, including a complete memory test. This design by IBM was modeled after their larger mainframe systems, which would perform a complete hardware test as part of their cold-start process.
The DMA command is issued by specifying a pair of a local address and a remote address: for example when a SPE program issues a put DMA command, it specifies an address of its own local memory as the source and a virtual memory address (pointing to either the main memory or the local memory of another SPE) as the target, together with a block size.
Low Pin Count interface Winbond chip Trusted Platform Module installed on a motherboard, and using the LPC bus. The Low Pin Count (LPC) bus is a computer bus used on IBM-compatible personal computers to connect low-bandwidth devices to the CPU, such as the BIOS ROM (BIOS ROM was moved to the Serial Peripheral Interface (SPI) bus in 2006 [1]), "legacy" I/O devices (integrated into Super I/O ...