Search results
Results from the WOW.Com Content Network
When a racon receives a radar pulse, it responds with a signal on the same frequency which puts an image on the radar display. This takes the form of a short line of dots and dashes forming a Morse character radiating away from the location of the beacon on the normal plan position indicator radar display. The length of the line usually ...
An ATC ground station consists of two radar systems and their associated support components. The most prominent component is the PSR. It is also referred to as skin paint radar because it shows not synthetic or alpha-numeric target symbols, but bright (or colored) blips or areas on the radar screen produced by the RF energy reflections from the target's "skin."
The primary radar's main function is to determine the location, the bearing and range to the aircraft. Air traffic controllers continuously monitor the positions of all the aircraft on the radar screen, and give directions to the pilots by radio to maintain a safe and orderly flow of air traffic in the airspace.
A beacon is an intentionally conspicuous device designed to attract attention to a specific location. A common example is the lighthouse , which draws attention to a fixed point that can be used to navigate around obstacles or into port.
Primary radar determines range and bearing to a target with reasonably high fidelity, but it cannot determine target elevation (altitude) reliably except at close range. SSR uses an active transponder (beacon) to transmit a response to an interrogation by a secondary radar.
AN/APS-21 search radar by Westinghouse Electric (1886) for part of AN/APQ-35 for Douglas F3D Skynight and Gloster Meteor NF; AN/APS-23 search radar by Western Electric for Convair B-36 North American B-45C Tornado Boeing B-47E Stratojet B-50 Superfortress B-52 Stratofortress Lockheed C-130 Hercules and Boeing C-135 Stratolifter part of AN/ASB-3
Radar echoes, showing a representation of the carrier. Pulse width also determines the radar's dead zone at close ranges. While the radar transmitter is active, the receiver input is blanked to avoid the amplifiers being swamped (saturated) or, (more likely), damaged.
Secondary surveillance radar antenna (flat rectangle, top) mounted on an ASR-9 primary airport surveillance radar antenna (curved rectangle, bottom).. The need to be able to identify aircraft more easily and reliably led to another wartime radar development, the Identification Friend or Foe (IFF) system, which had been created as a means of positively identifying friendly aircraft from unknowns.