enow.com Web Search

  1. Ads

    related to: internal tooth starlock push on locking washer machine with pump

Search results

  1. Results from the WOW.Com Content Network
  2. Washer (hardware) - Wikipedia

    en.wikipedia.org/wiki/Washer_(hardware)

    This type of washer is especially effective as a lock washer when used with a soft substrate, such as aluminium or plastic, [8] and can resist rotation more than a plain washer on hard surfaces, as the tension between washer and the surface is applied over a much smaller area (the teeth). There are four types: internal, external, combination ...

  3. Positive locking device - Wikipedia

    en.wikipedia.org/wiki/Positive_locking_device

    A positive locking device is a device used in conjunction with a fastener in order to positively lock the fastener. This means that the fastener cannot work loose from vibrations. The following is a list of positive locking devices: [1] A split beam nut; A castellated nut and a split pin; A hex nut or cap screw and a tab washer

  4. Toothpaste pump dispenser - Wikipedia

    en.wikipedia.org/wiki/Toothpaste_pump_dispenser

    An automatic toothpaste dispenser is a wall-mounted or counter-top device used to dispense toothpaste by pressing the toothbrush against the inside plates of the dispenser, so it automatically squeezes an appropriate amount of toothpaste and avoids waste.

  5. Worm drive - Wikipedia

    en.wikipedia.org/wiki/Worm_drive

    With spur gears, a gear of 12 teeth must match with a 240-tooth gear to achieve the same 20:1 ratio. Therefore, if the diametrical pitch (DP) of each gear is the same, then, in terms of the physical size of the 240 tooth gear to that of the 20 tooth gear, the worm arrangement is considerably smaller in volume.

  6. Retaining ring - Wikipedia

    en.wikipedia.org/wiki/Retaining_ring

    A circular push-on ring resembles a toothed washer, commonly fabricated in metal. These are installed by pressing onto the end of a grooved shaft, until the nut's inner teeth snap into the groove. The use of push nuts avoids the cost of threading a nut onto the end of the shaft during the manufacturing process.

  7. Keps nut - Wikipedia

    en.wikipedia.org/wiki/Keps_nut

    A Keps nut, (also called a k-lock nut [1] or washer nut), is a nut with an attached, free-spinning washer. It is used to make assembly more convenient. Common washer types are star-type lock washers, conical, and flat washers.

  1. Ads

    related to: internal tooth starlock push on locking washer machine with pump