Search results
Results from the WOW.Com Content Network
VLAN Trunking Protocol (VTP) is a Cisco proprietary protocol that propagates the definition of VLANs on the whole local area network. VTP is available on most of the Cisco Catalyst Family products. The comparable IEEE standard in use by other manufacturers is GARP VLAN Registration Protocol (GVRP) or the more recent Multiple VLAN Registration ...
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
VLAN Trunking Protocol (VTP) is a Cisco proprietary protocol that propagates the definition of Virtual Local Area Networks on the whole local area network. [1] To do this, VTP carries VLAN information to all the switches in a VTP domain. VTP advertisements can be sent over 802.1Q, and ISL trunks.
The Linksys WRT54G Wi-Fi series is a series of Wi-Fi–capable residential gateways marketed by Linksys, a subsidiary of Cisco, from 2003 until acquired by Belkin in 2013. A residential gateway connects a local area network (such as a home network ) to a wide area network (such as the Internet ).
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
Cisco Inter-Switch Link (ISL) is a Cisco proprietary link layer protocol that maintains VLAN information in Ethernet frames as traffic flows between switches and routers, or switches and switches. [1] ISL is Cisco's VLAN encapsulation protocol and is supported only on some Cisco equipment over the Fast and Gigabit Ethernet links.
It is a set of one or more infrastructure basic service sets on a common logical network segment (i.e. same IP subnet and VLAN). [18] Key to the concept is that the participating basic service sets appear as a single network to the logical link control layer by using the same SSID.
GARP was used by two applications: GARP VLAN Registration Protocol (GVRP) for registering VLAN trunking between multilayer switches, and by the GARP Multicast Registration Protocol (GMRP). The latter two were both mostly enhancements for VLAN-aware switches per definition in IEEE 802.1Q .