Search results
Results from the WOW.Com Content Network
In the same year, D-Link released one of the first Wi‑Fi Certified 802.11n draft 2.0 Wi-Fi routers (DIR-655), [4] which subsequently became one of the most successful draft 802.11n routers. [5] In May 2013, D-Link released its flagship draft 802.11ac Wireless AC1750 Dual-Band Router (DIR-868L), which at that point had attained the fastest ...
Router vendors typically design their routers to assign a default administrative distance to each kind of route. For example, on Cisco routers, routes issued by the Open Shortest Path First routing protocol have a lower default administrative distance than routes issued by the Routing Information Protocol. This is because, by default on Cisco ...
Router2 manages its attached networks and default gateway; router 3 does the same; router 1 manages all routes within the internal networks. Accessing internal resources If PC2 (172.16.1.100) needs to access PC3 (192.168.1.100), since PC2 has no route to 192.168.1.100 it will send packets for PC3 to its default gateway (router2).
A special case of private link-local addresses is the loopback interface. These addresses are private and link-local by definition since packets never leave the host device. IPv4 reserves the entire class A address block 127.0.0.0 / 8 for use as private loopback addresses. IPv6 reserves the single address ::1.
A router in a local area network (LAN) of a single organization is called an interior router. A router that is operated in the Internet backbone is described as exterior router. While a router that connects a LAN with the Internet or a wide area network (WAN) is called a border router, or gateway router. [24]
The All Routers multicast group addresses all routers on the same network segment. No 224.0.0.4 This address is used in the Distance Vector Multicast Routing Protocol (DVMRP) to address multicast routers. No 224.0.0.5 The Open Shortest Path First (OSPF) All OSPF Routers address is used to send Hello packets to all OSPF routers on a network ...
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
NetFlow is a feature that was introduced on Cisco routers around 1996 that provides the ability to collect IP network traffic as it enters or exits an interface. By analyzing the data provided by NetFlow, a network administrator can determine things such as the source and destination traffic, class of service, and the causes of congestion.