Search results
Results from the WOW.Com Content Network
Harry Franklin Vickers (October 1, 1898 – January 12, 1977) was an American inventor and industrialist. He grew up in Montana and southern California.He was called the "Father of Industrial Hydraulics" by the American Society of Mechanical Engineers, who gave him the Society's highest award, the ASME Medal, in 1956.
This is the pumping mechanism for the historical vane pump or motor. The term 'pressure balanced' comes from the fact that pressure in any chamber is matched by the same pressure in the diametrically opposite chamber and the hydraulic radial side thrust calculated by a 'side view area' and the two forces are opposite and cancel; hence the name ...
An eccentric rotary vane pump Another eccentric rotary-vane pump design. Note that modern pumps have an area contact between rotor and stator (and not a line contact). 1. pump housing 2. rotor 3. vanes 4. spring. A rotary vane pump is a type of positive-displacement pump that consists of vanes mounted to a rotor that rotates inside a cavity. In ...
The Vickers hardness test was developed in 1921 by Robert L. Smith and George E. Sandland at Vickers Ltd as an alternative to the Brinell method to measure the hardness of materials. [1] The Vickers test is often easier to use than other hardness tests since the required calculations are independent of the size of the indenter, and the indenter ...
During the design stage, the diagram also provides the basis for the development of system control schemes, allowing for further safety and operational investigations, such as a Hazard and operability study (HAZOP). To do this, it is critical to demonstrate the physical sequence of equipment and systems, as well as how these systems connect.
Gear pumps [1] [2] trochoid pumps [3] and vane pumps [a] are all commonly used. Plunger pumps have been used in the past, but these are now only used rarely, for small engines. To avoid the need for priming, the pump is always mounted low-down, either submerged or around the level of the oil in the sump. A short pick-up pipe with a simple wire ...
A positive displacement meter is a type of flow meter that requires fluid to mechanically displace components in the meter in order for flow measurement. Positive displacement (PD) flow meters measure the volumetric flow rate of a moving fluid or gas by dividing the media into fixed, metered volumes (finite increments or volumes of the fluid).
The pump's cavity is then sealed from the chamber, opened to the atmosphere, and squeezed back to a minute size. [14] [16] More sophisticated systems are used for most industrial applications, but the basic principle of cyclic volume removal is the same: [17] [18] Rotary vane pump, the most common; Diaphragm pump, zero oil contamination