Search results
Results from the WOW.Com Content Network
The diameter of the equivalent large format round shape is rounded to the nearest 1 ⁄ 8 inch to provide the bar size. For example, #9 bar has a cross section of 1.00 square inch (6.5 cm 2 ), and therefore a diameter of 1.128 inches (28.7 mm). #10, #11, #14, and #18 sizes correspond to 1 1 ⁄ 8 inch, 1 1 ⁄ 4 , 1 1 ⁄ 2 , and 2-inch square ...
The ACI Building Code Requirements put the following restrictions on amount of spiral reinforcement. ACI Code 7.10.4.2: For cast-in-place construction, size of spirals shall not be less than 3/8 in. diameter. ACI Code 7.10.4.3: Clear spacing between spirals shall not exceed 3 in., nor be less than 1in.
The EN 10080: Steel for the reinforcement of concrete is a European Standard.This standard is referenced by EN 1992.This standard specifies general requirements and definitions for performance characteristics of steel reinforcement suitable for welding, which is used for reinforcement of concrete structures, supplied as finished products:
A normal-size fiber for European shotcrete (1 mm diameter, 45 mm length—steel or plastic) will increase the concrete's tensile strength. Fiber reinforcement is most often used to supplement or partially replace primary rebar, and in some cases it can be designed to fully replace rebar. [41]
Rebar detailing is the discipline of preparing 'shop/placing' or 'fabrication' drawings or shop drawings of steel reinforcement for construction. Engineers prepare 'design drawings' that develop required strengths by applying rebar size, spacing, location, and lap of steel .
In the city of Kolkata, India, more than 10,000 manhole covers were taken in two months in 2004. These were replaced with concrete covers, but these were also stolen, this time for the rebar inside them. [24] In March and April 2012, Ajax, Ontario, and Niagara Falls, Ontario, [25] had dozens of manhole covers stolen.
The required concrete cover depends on several factors, including the environmental conditions to which the structure will be exposed, the size of the reinforcing steel, the concrete strength, and the type of structure being constructed. Generally, larger diameter reinforcement bars require more concrete cover than smaller ones.
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...