Search results
Results from the WOW.Com Content Network
An addressing mode specifies how to calculate the effective memory address of an operand by using information held in registers and/or constants contained within a machine instruction or elsewhere. In computer programming, addressing modes are primarily of interest to those who write in assembly languages and to compiler writers.
[b] [c] Normally, an addressing mode without an index would simply use a bare ModR/M byte without a SIB byte at all, but this is necessary to encode an ESP-relative address ([ESP+disp0/8/32]). When MOD=00, a BASE of 101, which would specify EBP with zero displacement, instead specifies no base register and a 32-bit displacement.
In compiler optimization, register allocation is the process of assigning local automatic variables and expression results to a limited number of processor registers. Register allocation can happen over a basic block ( local register allocation ), over a whole function/ procedure ( global register allocation ), or across function boundaries ...
In contrast to the PDP-11's 3-bit fields, the VAX-11's 4-bit sub-bytes resulted in 16 addressing modes (0–15). However, addressing modes 0–3 were "short immediate" for immediate data of 6 bits or less (the 2 low-order bits of the addressing mode being the 2 high-order bits of the immediate data, when prepended to the remaining 4 bits in ...
An instruction set architecture (ISA) is an abstract model of a computer, also referred to as computer architecture.A realization of an ISA is called an implementation.An ISA permits multiple implementations that may vary in performance, physical size, and monetary cost (among other things); because the ISA serves as the interface between software and hardware.
MIPS I has instructions that load and store 8-bit bytes, 16-bit halfwords, and 32-bit words. Only one addressing mode is supported: base + displacement. Since MIPS I is a 32-bit architecture, loading quantities fewer than 32 bits requires the datum to be either sign-extended or zero-extended to 32 bits.
The effective address is normally Y-C(T), where C(T) is either 0 for a tag of 0, the logical or of the selected index regisrs in multiple tag mode or the selected index register if not in multiple tag mode. However, the effective address for index register control instructions is just Y.
There are no other addressing modes, though. Thus, the direct addressing mode needs to be emulated using the four instructions mentioned earlier to load the address into a spare register; followed by an instruction to select that register as the index register; followed, finally, by the intended operation on the data variable that is pointed to ...