Search results
Results from the WOW.Com Content Network
The result of the test is an audiogram diagram which plots a person's hearing sensitivity at the tested frequencies. On an audiogram an "x" plot represents the softest threshold heard at each specific frequency in the left ear, and an "o" plot represents the softest threshold heard at each specific frequency in the right ear.
Pure-tone audiometry is the main hearing test used to identify hearing threshold levels of an individual, enabling determination of the degree, type and configuration of a hearing loss [1] [2] and thus providing a basis for diagnosis and management.
An audiogram is a graph that shows the audible threshold for standardized frequencies as measured by an audiometer. The Y axis represents intensity measured in decibels (dB) and the X axis represents frequency measured in hertz (Hz). [ 1 ]
Here's how to read an audiogram and a doctor's explanation of the most common results including sloping hearing loss, notched hearing loss, cookie-bite hearing loss and reverse-sloping hearing loss.
The most commonly used assessment of hearing is the determination of the threshold of audibility, i.e. the level of sound required to be just audible. This level can vary for an individual over a range of up to 5 decibels from day to day and from determination to determination, but it provides an additional and useful tool in monitoring the ...
A tone at the frequency of 4000 Hz is presented for 60 seconds at an intensity of 5 decibels above the patient's absolute threshold of hearing. If the patient stops hearing the tone before 60 seconds, the intensity level is increased by another 5 decibels with the procedure repeated until the tone can be heard for the full 60 seconds or until no decibel level can be found where the tone can be ...
Real ear measurement is the measurement of sound pressure level in a patient's ear canal developed when a hearing aid is worn. It is measured with the use of a silicone probe tube inserted in the canal connected to a microphone outside the ear and is done to verify that the hearing aid is providing suitable amplification for a patient's hearing loss. [2]
Unfortunately, not all areas on the audiogram (taking into account frequencies and intensity levels) are equally weighted. According to this procedure, the highest density of the audiogram dots is concentrated in the frequency region of 1-3 kHz , since this is the region containing the most speech information.