enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Pocket-hole joinery - Wikipedia

   en.wikipedia.org/wiki/Pocket-hole_joinery

   Some woodworkers lay out their project before drilling their pocket holes and mark the face of the board that they want to drill to ensure the hole is in the correct location. Most pocket joints are made by screwing into the face or the edge of the board rather than the end grain because the screw will grab better.

3. Butt joint - Wikipedia

   en.wikipedia.org/wiki/Butt_joint

   The pocket holes require two drilling operations to be completed. The first is to counterbore the pocket hole itself, which houses the screw head within the member. This hole is stopped 1 ⁄ 4 in (6.4 mm) or so from the edge of the frame member. The second step is to drill a pilot hole concentric with the pocket hole which extends through the ...

4. Biscuit joiner - Wikipedia

   en.wikipedia.org/wiki/Biscuit_joiner

   A biscuit joiner uses a small circular saw blade to cut a crescent-shaped hole (called the mouth) in the opposite edges of two pieces of wood or wood composite panels. An oval-shaped, highly dried and compressed wooden biscuit (beech or particle wood) is covered with glue, or glue is applied in the slot. The biscuit is immediately placed in the ...

5. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1] When drilling larger holes, where the drill bit is wider than the indentation produced by a center punch, the drilling of a pilot hole is usually needed. An automatic center punch operates without the ...

6. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The included angle of the spotting drill bit should be the same as, or greater than, the conventional drill bit so that the drill bit will then ...

7. Lath and plaster - Wikipedia

   en.wikipedia.org/wiki/Lath_and_plaster

   In use as early as 1900, rock lath (also known as "button board," "plaster board" or "gypsum-board lath"), is a type of gypsum wall board (essentially an early form of drywall) with holes spaced regularly to provide a 'key' for wet plaster. [3] Rock lath was typically produced in sheets sized 2 by 4 feet (610 by 1,220 mm).

8. Injection mold construction - Wikipedia

   en.wikipedia.org/wiki/Injection_mold_construction

   Register ring—Aligns injection molding machine screws with the injection mold. Usually made of case-hardened, medium carbon steel material (CHMCS). Sprue bushing — The bush has a taper hole of 3° to 5° and is usually made of CHMCS. The material enters the mold through the sprue bush.

9. Pilot hole - Wikipedia

   en.wikipedia.org/wiki/Pilot_hole

   A pilot hole may be drilled the full extent of the final hole, or may only be a portion of the final depth. The pilot drill may be a standard twist drill, another type of drill bit appropriate for the material, or, when the primary purpose is precisely locating a hole, may be made with a short, stiff center drill.