Ads
related to: molex 6 position connector assembly kit price
Search results
Results from the WOW.Com Content Network
In 1983, Molex introduced the 8981 connector under the trademark Disk Drive Power Connection System, [5] which was fully compatible with the AMP Mate-n-Lok connector. [6] The Molex 8981 series was only produced in a 4-position option, unlike the Mate-n-Lok family which includes many other contact arrangements.
The first types of small modular telephone connectors were created by AT&T in the mid-1960s for the plug-in handset and line cords of the Trimline telephone. [1] Driven by demand for multiple sets in residences with various lengths of cords, the Bell System introduced customer-connectable part kits and telephones, sold through PhoneCenter stores in the early 1970s. [2]
Aside from flower pots, Molex also sold salt shakers before it expanded into electrical connectors and sensors. [6] Later they made connectors for General Electric and other appliance manufacturers out of the same plastic. [7] Molex acquired Woodhead Industries in 2006; [8] the largest acquisition in the former's history at the time.
A compact board with Molex connectors, aimed at environments where vibration could be an issue. DragonFly features the ATmega1280 and have all 86 I/O lines pinned out to connectors. Femtoduino [160] [dead link ] Femtoduino [161] ATmega328P-MU Femtoduino PCB vs Dime An ultra-small (20.7x15.2 mm) Arduino compatible board designed by Fabio ...
A compact board with Molex connectors, aimed at environments where vibration could be an issue. DragonFly features the ATmega1280 and have all 86 I/O lines pinned out to connectors. Femtoduino [173] [dead link ] ATmega328P-MU Femtoduino [174] Femtoduino PCB vs Dime An ultra-small (20.7x15.2 mm) Arduino compatible board designed by Fabio ...
A 34-pin control cable and a 20-pin data cable for an ST-412 drive connected to a controller card. A 4-pin Molex connector supplying power to the drive can not be seen in this image. In the ST-506 interface, the drive connects to a controller card with two ribbon cables carrying signals, while a third cable provides power.
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.
Schematic symbols for male and female connector pins. In electrical and mechanical trades and manufacturing, each half of a pair of mating connectors or fasteners is conventionally assigned the designation male or female, [1] a distinction referred to as its gender. [2] The female connector is generally a receptacle that receives and holds the ...
Ads
related to: molex 6 position connector assembly kit price