Search results
Results from the WOW.Com Content Network
TRIAC. For other uses, see Triac. A TRIAC (triode for alternating current; also bidirectional triode thyristor or bilateral triode thyristor[ 1 ]) is a three-terminal electronic component that conducts current in either direction when triggered. The term TRIAC is a genericised trademark. TRIACs are a subset of thyristors (analogous to a relay ...
A silicon controlled rectifier or semiconductor controlled rectifier is a four-layer solid-state current -controlling device. The name "silicon controlled rectifier" is General Electric 's trade name for a type of thyristor. The principle of four-layer p–n–p–n switching was developed by Moll, Tanenbaum, Goldey, and Holonyak of Bell ...
Phase-fired control (PFC) is often used to control the amount of voltage, current or power that a power supply feeds to its load. It does this to create an average value at its output. If the supply has a DC output, its time base is of no importance in deciding when to pulse the supply on or off, as the value that will be pulsed on and off is ...
Electronic components have a number of electrical terminals or leads. These leads connect to other electrical components, often over wire, to create an electronic circuit with a particular function (for example an amplifier, radio receiver, or oscillator). Basic electronic components may be packaged discretely, as arrays or networks of like ...
Zero-crossing control (or burst-fire control) is an approach for electrical control circuits that starts operation with the AC load voltage at close to 0 volts in the AC cycle. [ 1 ] This is in relation to solid-state relays, such as TRIACs and silicon controlled rectifiers. [ 1 ] The purpose of the circuit is to start the TRIAC conducting very ...
Solid-state relay. A solid state relay (SSR) is an electronic switching device that switches on or off when an external voltage (AC or DC) is applied across its control terminals. They serve the same function as an electromechanical relay, but solid-state electronics contain no moving parts and have a longer operational lifetime.
A crowbar circuit is an electrical circuit used for preventing an overvoltage or surge condition of a power supply unit from damaging the circuits attached to the power supply. It operates by putting a short circuit or low resistance path across the voltage output (V o), like dropping a crowbar across the output terminals of the power supply.
Power semiconductor device. Appearance. A power semiconductor device is a semiconductor device used as a switch or rectifier in power electronics (for example in a switch-mode power supply). Such a device is also called a power device or, when used in an integrated circuit, a power IC. A power semiconductor device is usually used in ...