Search results
Results from the WOW.Com Content Network
A spectrum analyzer is also used to determine, by direct observation, the bandwidth of a digital or analog signal. A spectrum analyzer interface is a device that connects to a wireless receiver or a personal computer to allow visual detection and analysis of electromagnetic signals over a defined band of frequencies.
A spectrum analyser – typically used as the measuring instrument in two-tone testing. Two-tone testing is a means of testing electronic components and systems, particularly radio systems, for intermodulation distortion. It consists of simultaneously injecting two sinusoidal signals of different frequencies (tones) into the component or system.
A modern Elecraft P3 Panadapter RBY-1, US Navy Panoramic Radio Adapter RBY-1 with Hallicrafters SX-28.The Panoramic Radio Adapter is the upper part. The radio spectrum scope (also radio panoramic receiver, panoramic adapter, pan receiver, pan adapter, panadapter, panoramic radio spectroscope, panoramoscope, panalyzor and band scope) was invented by Marcel Wallace - and measures and shows the ...
Some radio users have inappropriately started using the Circuit Merit telephone line quality measurement. [ citation needed ] This format is unsuitable for radiotelegraph or radio-telephony use because it focuses on voice-to-noise ratios, for judging whether a particular telephone line is suitable for commercial (paying customer) use, and does ...
Measurement from a spectrum analyzer showing a noise-like measurement from an unspecified component.. In signal theory, the noise floor is the measure of the signal created from the sum of all the noise sources and unwanted signals within a measurement system, where noise is defined as any signal other than the one being monitored.
Spectrum analyzer based measurement can show the phase-noise power over many decades of frequency; e.g., 1 Hz to 10 MHz. The slope with offset frequency in various offset frequency regions can provide clues as to the source of the noise; e.g., low frequency flicker noise decreasing at 30 dB per decade (= 9 dB per octave).
An SWR meter for CB radio equipment. A standing wave ratio meter, SWR meter, ISWR meter (current "I" SWR), or VSWR meter (voltage SWR) measures the standing wave ratio (SWR) in a transmission line. [a] The meter indirectly measures the degree of mismatch between a transmission line and its load (usually an antenna).
An antenna analyzer measuring SWR and complex impedance of a dummy load. MFJ-269, MFJ Enterprises Inc. An antenna analyzer or in British aerial analyser (also known as a noise bridge, RX bridge, SWR analyzer, or RF analyzer) is a device used for measuring the input impedance of antenna systems in radio electronics applications.