Search results
Results from the WOW.Com Content Network
A bass reflex system (also known as a ported, vented box or reflex port) is a type of loudspeaker enclosure that uses a port (hole) or vent cut into the cabinet and a section of tubing or pipe affixed to the port. [1] [2] This port enables the sound from the rear side of the diaphragm to increase the efficiency of the system at low frequencies ...
MTX Audio loudspeaker enclosures (with rear panel reflex port tubes) which can mount 15-inch woofers, mid-range drivers and horn and/or compression tweeters. In this photo, only one driver is mounted. A cabinet with loudspeakers mounted in the holes. Number 1 is a mid-range driver. Number 2 is a high-range driver.
A transmission line loudspeaker is a loudspeaker enclosure design which uses the topology of an acoustic transmission line within the cabinet, compared to the simpler enclosures used by sealed (closed) or ported (bass reflex) designs.
Small [1] [2] and Hurlburt [3] have published the results of research into the analysis and design of passive-radiator loudspeaker systems. The passive-radiator principle was identified as being particularly useful in compact systems where vent realization is difficult or impossible, but it can also be applied satisfactorily to larger systems.
A loudspeaker (commonly referred to as a speaker or, more fully, a speaker system) is a combination of one or more speaker drivers, an enclosure, and electrical connections (possibly including a crossover network). The speaker driver is an electroacoustic transducer [1]: 597 that converts an electrical audio signal into a corresponding sound. [2]
All speaker drivers have a means of electrically inducing back-and-forth motion. Typically there is a tightly wound coil of insulated wire (known as a voice coil) attached to the neck of the driver's cone. In a ribbon speaker, the voice coil may be printed or bonded onto a sheet of very thin paper, aluminum, fiberglass or plastic.
This article lists manufacturers of bass amplifiers, loudspeakers, and other amplification-related items such as preamplifiers. The amplifiers and loudspeakers used to amplify bass instruments (e.g., the bass guitar, double bass and similar instruments) are distinct from other types of amplification systems due to the particular challenges associated with low-frequency sound reproduction.
A line array is a loudspeaker system that is made up of a number of usually identical loudspeaker elements mounted in a line and fed in phase, to create a near-line source of sound. The distance between adjacent drivers is close enough that they constructively interfere with each other to send sound waves farther than traditional horn-loaded ...