Search results
Results from the WOW.Com Content Network
Leupold & Stevens, Inc. is an American manufacturer of telescopic sights, red dot sights, binoculars, rangefinders, spotting scopes, and eyewear located in Beaverton, Oregon, United States. The company, started in 1907, is on its fifth generation of family ownership.
The scope base is the attachment interface on the rifle's receiver, onto which the scope rings or scope mount are fixed. Early telescopic sights almost all have the rings that are fastened directly into tapped screw holes on the receiver, hence having no additional scope base other than the receiver top itself.
A Leupold telescopic sight mounted on a dovetailed rifle receiver via two scope rings From left: A sketch of a cross section on a Zeiss rail and ring mount, both with a Picatinny rail interface. Scope mounts are rigid implements used to attach (typically) a telescopic sight or other types of optical sights onto a firearm.
Similarly, an adjustment click on a scope with 0.2 mrad adjustment will move the point of bullet impact 2 cm at 100 m and 4 cm at 200 m, etc. When using a scope with both mrad adjustment and a reticle with mrad markings (called a mrad/mrad scope), the shooter can spot his own bullet impact and easily correct the sight if needed.
This is the process of adjusting the scope so that the bullets' points-of-impact are at the point-of-aim (centre of scope or scope's cross-hairs) for a specific distance. [9] [page needed] A rifle and scope should retain its zero as long as possible under all conditions to reduce the need to re-zero during missions. [9] [page needed]
Some troops leave the battlefield injured. Others return from war with mental wounds. Yet many of the 2 million Iraq and Afghanistan veterans suffer from a condition the Defense Department refuses to acknowledge: Moral injury.
Rear, rotating diopter drum sight of a SIG SG 550 service rifle.The viewing aperture above the "3" (denoting the 300 m setting) can be seen. The diopter is in principle a vertically and horizontally (elevation and windage) adjustable occluder with a small hole (aperture), and is placed close in front of the shooter's aiming eye.
With tangent sights, the rear sight is often used to adjust the elevation, and the front the windage. The M16A2 later M16 series rifles have a dial adjustable range calibrated rear sight, and use an elevation adjustable front sight to "zero" the rifle at a given range. The rear sight is used for windage adjustment and to change the zero range.