Search results
Results from the WOW.Com Content Network
MCA-Jet was a simpler system that sent the same air/fuel mixture to all intake and MCA-Jet valves. Each MCA-Jet valve is quite small and may be prone to carbon build-up, causing the MCA-Jet valve(s) to stick open. If a Mitsubishi-designed engine has low compression, the MCA-Jet valve(s) could be the cause. Each MCA-Jet valve and valve seat are ...
A version with an early iteration of Mitsubishi's MCA lean-burn system (MCA-IIB), fulfilling the intermediate Japanese exhaust regulations for 1975, was called G32A. This was built for less than one year, as the new MCA engine arrived in November 1975. Those with the later, cleaner yet, "MCA-Jet" system were called G32B.
Using the PRV method of control, means that the pressure of the feed oil must be below a critical value (usually controlled by other valves which can leak out excess oil back to tank if it exceeds the critical value). The valve opens at a certain pressure and oil is kept moving at a constant rate into the bearing chamber.
"MCA" stood for "Mitsubishi Clean Air", reflecting Japan's new air quality laws. The MCA-II was cleaner yet, and with balance shafts it also offered a much smoother run, at the loss of a few horsepower. The Sports engine did not meet the stricter emissions laws, which led to the demise of the Skipper.
The quantity of bleed air flowing to the AC pack is regulated by the flow control valve (FCV). One FCV is installed for each PACK. A normally closed isolation valve prevents air from the left bleed system from reaching the right PACK (and vice versa), although this valve may be opened in the event of loss of one bleed system.
The basic operation of the PDE is similar to that of the pulse jet engine. In the pulse jet, air is mixed with fuel to create a flammable mixture that is then ignited in an open chamber. The resulting combustion greatly increases the pressure of the mixture to approximately 100 atmospheres (10 MPa), [8] which then expands through a nozzle for ...
Instrumentation and control engineering is a vital field of study offered at many universities worldwide at both the graduate and postgraduate levels. This discipline integrates principles from various branches of engineering, providing a comprehensive understanding of the design, analysis, and management of automated systems.
The design of the AL-31 turbofan began in the 1970s under the designation izdeliye 99 [N 1] by the Lyulka design bureau, also known as Lyulka-Saturn. With an emphasis on greater fuel efficiency over turbojets for longer range, the 12.5 tonnes-force (122.6 kN; 27,560 lbf) class turbofan engine was intended to power the heavy PFI (Russian: ПФИ, short for: перспективного ...