Search results
Results from the WOW.Com Content Network
Tin dioxide is the most common material used in semiconductor gas sensors, [9] and the electrical resistance in the sensor is decreased when it comes in contact with the monitored gas. The resistance of the tin dioxide layer, typically in the range of 10 to 500 kΩ in air, can drop to a small fraction of this value in the presence of a reducing ...
Sensors are usually designed so that the gas supply is limited by diffusion, and thus the output from the sensor is linearly proportional to the gas concentration. This linear output is one of the advantages of electrochemical sensors over other sensor technologies (e.g. infrared), whose output must be linearized before they can be used.
Arduino (/ ɑː r ˈ d w iː n oʊ /) is an Italian open-source hardware and software company, project, and user community that designs and manufactures single-board microcontrollers and microcontroller kits for building digital devices.
The first Arduino board based on an ARM processor. Features 2 channel 12-bit DAC, 84 MHz clock frequency, 32-bit architecture, 512 KB flash and 96 KB SRAM. Unlike most Arduino boards, it operates on 3.3 V and is not 5 V tolerant. Arduino Yún [21] ATmega32U4, [22] Atheros AR9331 16 MHz, 400 MHz Arduino 68.6 mm × 53.3 mm [ 2.7 in × 2.1 in ]
The gas is pumped or diffuses into the light tube, and the electronics measure the absorption of the characteristic wavelength of light. NDIR sensors are most often used for measuring carbon dioxide. [2] The best of these have sensitivities of 20–50 PPM. [2] Typical NDIR sensors cost in the (US) $100 to $1000 range.
The Arduino Nano is an open-source breadboard-friendly microcontroller board based on the Microchip ATmega328P microcontroller (MCU) and developed by Arduino.cc and initially released in 2008. It offers the same connectivity and specs of the Arduino Uno board in a smaller form factor. [1]
The STK600 uses a base board, a signal routing board, and a target board. The base board is similar to the STK500, in that it provides a power supply, clock, in-system programming, an RS-232 port and a CAN (Controller Area Network, an automotive standard) port via DE9 connectors, and stake pins for all of the GPIO signals from the target device.
An oxygen sensor (or lambda sensor, where lambda refers to air–fuel equivalence ratio, usually denoted by λ) or probe or sond, is an electronic device that measures the proportion of oxygen (O 2) in the gas or liquid being analyzed. [1] It was developed by Robert Bosch GmbH during the late 1960s under the supervision of Günter Bauman. [1]