Search results
Results from the WOW.Com Content Network
Polyethylene absorbs almost no water; the gas and water vapour permeability (only polar gases) is lower than for most plastics. Oxygen, carbon dioxide and flavorings, on the other hand, can pass it easily. Polyethylene burns slowly with a blue flame having a yellow tip and gives off an odour of paraffin (similar to candle flame). The material ...
Most plastics are derived from natural gas and petroleum, and a small fraction from renewable materials. One such material polylactic acid. [2] Between 1950 and 2017, 9.2 billion metric tons of plastic are estimated to have been made; more than half of this has been produced since 2004.
It converts synthesis gas (syngas) to methanol, and then converts the methanol to ethylene and/or propene. The process produces water as a by-product. Synthesis gas is produced from the reformation of natural gas or by the steam-induced reformation of petroleum products such as naphtha, or by gasification of coal or natural gas.
Polystyrene can be solid or foamed. General-purpose polystyrene is clear, hard, and brittle. It is an inexpensive resin per unit weight. It is a poor barrier to air and water vapor and has a relatively low melting point. [6] Polystyrene is one of the most widely used plastics, with the scale of its production being several million tonnes per ...
As a liquid or a gas, pure styrene will polymerise spontaneously to polystyrene, without the need of external initiators. [29] This is known as autopolymerisation . At 100 °C it will autopolymerise at a rate of ~2% per hour, and more rapidly than this at higher temperatures. [ 22 ]
Quantities of natural gas are measured in standard cubic meters (cubic meter of gas at temperature 15 °C (59 °F) and pressure 101.325 kPa (14.6959 psi)) or standard cubic feet (cubic foot of gas at temperature 60.0 °F and pressure 14.73 psi (101.6 kPa)), 1 standard cubic meter = 35.301 standard cubic feet.
A Assuming an altitude of 194 metres above mean sea level (the worldwide median altitude of human habitation), an indoor temperature of 23 °C, a dewpoint of 9 °C (40.85% relative humidity), and 760 mmHg sea level–corrected barometric pressure (molar water vapor content = 1.16%).
It may be of low density or high density depending upon the process used in its manufacturing. It is resistant to moisture and most of the chemicals. It is flexible at room temperature (and low temperature) and can be heat sealed. Since it is an inexpensive plastic it is made in large amounts to cater to the demand. For example: