Search results
Results from the WOW.Com Content Network
Before installing a check dam, engineers inspect the site. Standard practices call for the drainage area to be ten acres or less. [3] [9] The waterway should be on a slope of no more than 50% and should have a minimum depth to bedrock of 2 ft (0.61 m). [14] Check dams are often used in natural or constructed channels or swales.
A linear drain A Channel Drain. There are four common types of trench drains which are based on forming or installation method. These are cast-in-place, pre-cast concrete, liner systems and former systems. Newer stainless steel drains are available for residential and commercial shower installs and more commonly called "channel drains".
The interception rate of channel drainage is greater than point drainage and the excavation required is usually much less deep. The surface opening of channel drainage usually comes in the form of gratings (polymer, plastic, steel or iron) or a single slot (slot drain) that run along the ground surface (typically manufactured from steel or iron).
"Over a mile long reach [of the water channel] adds up to over 1.5 acre of land needed for the two stage drainage ditch design". This acreage of land may already be currently used for other purposes or contains infrastructure and subsurface gas or sewer lines. Thus, the larger the channel is, the more soil, and thus, increased funds required to ...
A minimum energy loss culvert or waterway is a structure designed with the concept of minimum head loss. The flow in the approach channel is contracted through a streamlined inlet into the barrel where the channel width is minimum, and then it is expanded in a streamlined outlet before being finally released into the downstream natural channel.
A diagram of a traditional French drain. A French drain [1] (also known by other names including trench drain, blind drain, [1] rubble drain, [1] and rock drain [1]) is a trench filled with gravel or rock, or both, with or without a perforated pipe that redirects surface water and groundwater away from an area.
In geotechnical engineering, an interceptor ditch is a small ditch or channel constructed to intercept and drain water to an area where it can be safely discharged. [1] These are used for excavation purposes of limited depth made in a coarse-grained soils. These are constructed around an area to be dewatered.
A common type of this style fitting is a "hex bushing" with a hex head for installation with a pipe wrench. A double-tapped bushing is more compact than a reducer but not as flexible. While a double-tapped bushing has a more minor female thread concentric to a larger male thread (and thus couples a smaller male end to a larger female), a ...