enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Low-flow fixtures - Wikipedia

   en.wikipedia.org/wiki/Low-flow_fixtures

   In the United States, Older conventional toilet models, typically those built before 1982, can use 5 to 7 gallons of water per flush. Toilets from the era of 1982-1993 may use a somewhat smaller 3.5 gpf. Modern washdown and symphonic variant standard flush toilets in the United States use 1.6 gpf or 6 lpf (liters per flush). [12]

3. Flush toilet - Wikipedia

   en.wikipedia.org/wiki/Flush_toilet

   A typical flush toilet is a fixed, vitreous ceramic bowl (also known as a pan) which is connected to a drain. After use, the bowl is emptied and cleaned by the rapid flow of water into the bowl. This flush may flow from a dedicated tank (cistern), a high-pressure water pipe controlled by a flush valve, or by manually pouring water into the bowl.

4. Flushometer - Wikipedia

   en.wikipedia.org/wiki/Flushometer

   The valve is shut off at both its top and bottom positions. A second valve, placed within the main cylinder valve, releases the water in the topmost pressure chamber when the flush lever is activated, sending the main cylinder valve shooting upwards. The topmost pressure chamber slowly refills through its narrow passageway, pushing the valve ...

5. Ballcock - Wikipedia

   en.wikipedia.org/wiki/Ballcock

   When the handle of a flush toilet with a tank (British, cistern) is turned, a discharge mechanism is activated by means of a rod or chain. The mechanism may be a flapper valve, which is designed to sink more slowly than the water - allowing the water to exit to the toilet bowl below, so that the tank may empty.

6. Low-flush toilet - Wikipedia

   en.wikipedia.org/wiki/Low-flush_toilet

   A low-flush toilet (or low-flow toilet or high-efficiency toilet) is a flush toilet that uses significantly less water than traditional high-flow toilets. Before the early 1990s in the United States, standard flush toilets typically required at least 3.5 gallons (13.2 litres) per flush and they used float valves that often leaked, increasing their total water use.

7. Sloan Valve Company - Wikipedia

   en.wikipedia.org/wiki/Sloan_Valve_Company

   The company was founded by William Elvis Sloan in Chicago, Illinois in 1906 with the introduction of the Royal flushometer, a valve to release a measured amount of water to flush a urinal or toilet. Initial sales were very poor: only a single Royal model flushometer was sold in 1906, and two in 1907.