enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Aluminium joining - Wikipedia

   en.wikipedia.org/wiki/Aluminium_joining

   Aluminium alloys are often used due to their high strength-to-weight ratio, corrosion resistance, low cost, high thermal and electrical conductivity.There are a variety of techniques to join aluminium including mechanical fasteners, welding, adhesive bonding, brazing, soldering and friction stir welding (FSW), etc. Various techniques are used based on the cost and strength required for the joint.

3. Reynolds 531 - Wikipedia

   en.wikipedia.org/wiki/Reynolds_531

   The approximate alloying composition of 531 tubing is 1.5% Mn, 0.25% Mo, 0.35% C, and is similar to the old British BS970 En 16/18 steel (EN 16 is similar to grade BS970 605M36). Its mechanical properties and response to heat treatment are broadly similar to the AISI 4130 standard alloy steel, also used for bicycle frames, motorcycles, as well ...

4. Flash welding - Wikipedia

   en.wikipedia.org/wiki/Flash_welding

   The aluminum industry uses flash welding to join aluminum, steel, and copper in various current-carrying conductors called busbars. The steel is used for strength, the copper is used for conductivity, and the aluminum is used for its combination of cost and conductivity.

5. Reynolds Technology - Wikipedia

   en.wikipedia.org/wiki/Reynolds_Technology

   The Patent Butted Tube Co., Ltd., the predecessor of the present company, was spun off from John Reynolds' original company in 1898. In 1923 the Patent Butted Tube Co., Ltd changed its name to Reynolds Tube Co., Ltd. and retained this name up until 1928 when it was acquired by Tube Investments, Ltd and became TI Reynolds 531 Ltd.

6. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

7. Flare fitting - Wikipedia

   en.wikipedia.org/wiki/Flare_fitting

   The tool used to flare tubing consists of a die that grips the tube, and either a mandrel or rolling cone is forced into the end of the tube to form the flare by cold working. The most common flare fitting standards in use today are the 45° SAE flare [ 2 ] [ 3 ] ,the 37° JIC flare, and the 37° AN flare.